Sony XVS-7000 Users Guide - Page 120
Using the sub mask, Utility 1 Bus
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
4 Depending on the selection in step 3, set the following parameters. When [Box] is selected No. Parameter Adjustment 1 Top Position of top side 2 Left Position of left side 3 Right Position of right side 4 Bottom Position of bottom side 5 Soft Degree of softness of box When [Pattern] is selected No. Parameter Adjustment 1 Size Pattern size 2 Soft Degree of softness of pattern edge 5 Pattern Pattern number a) a) The patterns are the same as standard wipe patterns 1 to 24. You can also make a pattern selection by pressing [Mask Ptn Select] in the Main Mask menu to display the Mask Ptn Select menu (1113.1). Press the desired pattern (1 to 24) to select it, and set the [Size] and [Soft] parameters. 5 To invert the mask source, press [Mask Invert], turning it on. 6 When a pattern is selected as a mask source, set the pattern modifiers as required. When selecting [Position] and setting the pattern position No. Parameter Adjustment 1 Position H Horizontal position a) 2 Position V Vertical position a) a) See page 145. When selecting [Multi] and replicating the pattern No. Parameter Adjustment 1 H Multi Number of repetitions of pattern horizontally 2 V Multi Number of repetitions of pattern vertically 3 Invert Type Pattern layout a) a) See page 147. When selecting [Aspect] and adjusting the pattern aspect ratio No. Parameter Adjustment 1 Aspect Aspect ratio a) a) See page 146. When selecting [Angle] in the group and slanting the pattern No. Parameter Adjustment 1 Angle Rotation angle of pattern a) a) See page 146. When selecting [Speed] in the group and rotating the pattern at a constant speed No. Parameter Adjustment 1 Speed Rotation speed of pattern a) a) See page 146. Using the sub mask 1 Open the M/E-1 >Key1 >Sub Mask menu (1114). 2 In the group, select the mask type. Key Mask: Masks a part of a key. Bkgd Mask: Masks a part of a background. 3 In the group, select the mask source. Wipe: Wipe pattern selected for a transition. Press [Pattern Select] to open the M/E-1 >Wipe >Main Pattern menu (1151), and select a pattern and set modifiers (see page 140). Note In patterns selected for a mask, modifiers for wipe direction and edges are disabled. Utility 1 Bus: Signal selected on the utility 1 bus. On the cross-point control block, press delegation button [UTL1] on the cross-point pad and select a signal using the cross-point buttons. Notes • On the cross-point control block in key/AUX bus delegation mode, press the [UTIL1] button in the 1st row and select a signal using the cross-point buttons in the 2nd row. • You can assign the utility 1 bus using the [UTIL] button on the cross-point pad of the cross-point control block (see page 79). • You can assign a utility 1 bus delegation button to the 1st row or 2nd row of the AUX bus control block (AUX bus operation mode) in the Setup menu (see page 417). 4 Depending on the selection in step 3, set the following parameters. 120