Sony XVS-7000 Users Guide - Page 471
Settings Relating to Device Connections, In the Engineering Setup >Switcher >Device Interface
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 471 highlights
2 In the status area, select the target AUX bus to set. To select AUX buses, set the [Num] parameter. The specified number of AUX buses are selected from the currently selected AUX bus. 3 In the group, select a group (Link1 to Link12). AUX buses configured in the same group form a link group. Settings Relating to Device Connections Assigning an AUX Bus to Ext In on a DME You can set the signal (AUX bus output) that is input on Ext In on a DME. 1 In the Engineering Setup >Switcher >Device Interface menu (7337), press [DME Interface]. The DME Interface menu (7337.7) appears. 2 In the list on the left, select Ext In on the target DME channel to set. 3 In the list on the right, select the AUX bus to assign to Ext In. 471
471
2
In the status area, select the target AUX bus to set.
To select AUX buses, set the [Num] parameter. The
specified number of AUX buses are selected from the
currently selected AUX bus.
3
In the <Link Group Select> group, select a group
(Link1 to Link12).
AUX buses configured in the same group form a link
group.
Settings Relating to
Device Connections
Assigning an AUX Bus to Ext In on a
DME
You can set the signal (AUX bus output) that is input on
Ext In on a DME.
1
In the Engineering Setup >Switcher >Device Interface
menu (7337), press [DME Interface].
The DME Interface menu (7337.7) appears.
2
In the list on the left, select Ext In on the target DME
channel to set.
3
In the list on the right, select the AUX bus to assign to
Ext In.