Sony XVS-7000 Users Guide - Page 189
Setting the Safe Title Area, Displaying a List of Transition Rates, and Changing the Settings
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 189 highlights
Note The enable/disable setting is applied to all Virtual Shot Box, Virtual Menu, and Virtual Panel instances connected to the control panel. 1 Open the Misc >Enable >Port Enable menu (3211). 2 Press [Web UI Enable] to enable/disable the function. The setting switches between enabled (button is lit) and disabled (button is not lit) each time [Web UI Enable] is pressed. the selection in the group of the Engineering Setup >Switcher >Transition menu (7334) on each bank. When [Same] (same setting for key insertion and key removal) is selected in the group: Only "Key" appears. When [Independ] (independent settings for key insertion and key removal) is selected in the group: "Key (On)" and "Key (Off)" appear. For details, see "Selecting independent key transition mode" (page 467). Setting the Safe Title Area You can enable/disable the safe title area for each output. 1 Open the Misc >Safe Title menu (3221). 2 Select the target signal. Notes • It is not possible to change the setting for outputs for which the safe title area is disabled in the Setup menu. For details, see "Setting the Safe Title Area" (page 457). • If an input with through mode enabled is selected for output on an AUX bus or edit preview bus with through mode enabled, the safe title area becomes disabled. 3 Press [Safe Title] to enable/disable the function. The safe title area switches to enabled (button is lit) or disabled (button is not lit) each time the button is pressed. Displaying a List of Transition Rates and Changing the Settings In the Misc >Transition >Key/ME/FTB menu (3231), you can display a list of the M/E (or PGM/PST) transition rates and independent key transition rates for each bank, and change the settings. These settings are linked to the corresponding transition rate setting operations on each bank. You can also display and set the fade-to-black transition rate. Misc >Transition >Key/ME/FTB menu The display of the independent key transition rate in the Misc >Transition >Key/ME/FTB menu (3231) depends on Setting the transition rate To set the M/E transition rate This section describes setting on the M/E-1 bank as an example. 1 In the status area of the Misc >Transition >Key/ME/ FTB menu (3231), select [M/E-1]. 2 In the group, press [Transition]. 3 Set the transition rate. No. Parameter Adjustment 1 Transition Transition rate Rate Note When a clip transition is selected as the transition type, it is not possible to change the transition rate in the Key/ME/FTB menu. To set the independent key transition rate This section describes setting key 1 to key 4 on the M/E-1 bank as an example. 1 In the status area of the Misc >Transition >Key/ME/ FTB menu (3231), select [M/E-1]. 2 In the group, press [Key K1-K4]. When [Independ] is selected in the group of the Engineering Setup >Switcher >Transition menu (7334), press [Key (On) K1-K4] or [Key (Off) K1-K4]. 3 Set the transition rate. No. Parameter Adjustment 1 Key1 Trans Key 1 transition rate Rate 189