Sony XVS-7000 Users Guide - Page 459
Setting the Internal Format, Converters, Assigning an Ext Out signal to an M/E, dedicated output
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 459 highlights
2 Press [M/E Ext Out Assign]. The M/E Ext Output Assign menu (7333.11) appears. The status area shows the Ext Out list of each switcher bank on the left and the selectable output signal list on the right. 3 In the list on the left, select the target Ext Out to set. 4 In the list on the right, select an output signal. 5 Press [Set]. Assigning an Ext Out signal to an M/E dedicated output You can set an Ext Out signal for each group of four M/E dedicated outputs (connectors 1 to 4, 5 to 8, 9 to 12, 13 to 16). You can select from Ext Out1 and Ext Out2 on each switcher bank, configured using the M/E Ext Output Assign menu (7333.11), as the output to assign to an M/E dedicated output. 1 In the Engineering Setup >Switcher >Output menu (7333), press [M/E Dedicated Out Assign]. The M/E Dedicated Output Assign menu (7333.8) appears. The status area shows the M/E dedicated output list on the left and the switcher bank Ext Out list on the right. 2 In the list on the left, select the target M/E dedicated output to set. 3 In the list on the right, select an Ext Out signal. 4 Press [Set]. Setting the Internal Format Converters Up to 16 channels of internal format converter are supported by installing an XKS-8460 Format Converter Board. Note On the XVS-9000, internal format converters are not available. Setting the format converter configuration You can set FC channels (FC1 to FC16) in 4-channel groups (FC1 to FC4, FC5 to FC8, FC9 to FC12, FC13 to FC16) for input use (input signal conversion) or output use (output signal conversion). Notes • On the XVS-7000, FC9 to FC16 are reserved for output use only. • When the switcher signal format is 1080i or 720P, the FC1 to FC4 setting and FC5 to FC8 setting are linked, likewise the FC9 to FC12 setting and FC13 to FC16 setting. 1 In the Engineering Setup >Switcher >Output menu (7333), press [Internal FC]. The Internal FC menu (7333.15) appears. 2 Press [FC Config]. The FC Config menu (7333.16) appears. 3 In the status area, select the target FC channel to set. 4 In the group, select one of the following. Input: Set the format converter for input use. Output: Set the format converter for output use. To clear the setting Press [Clear]. 5 Press [Execute]. Enabling/disabling the 720P converter When the switcher signal format is 1080P, you can enable/ disable the 720P converter function. The following conversion formats can be selected depending on the 720P converter setting. 720P converter Disabled Enabled Input signal format • 1080P (Level A) • 1080P (Level B) • 1080i • 1080P (Level A) • 720P Output signal format • 1080P (Level A) • 1080P (Level A) • 720P 1 In the Engineering Setup >Switcher >Output menu (7333), press [Internal FC]. The Internal FC menu (7333.15) appears. 2 Press [FC Config]. The FC Config menu (7333.16) appears. 3 Press [720P I/O Converter] to enable/disable the 720P converter. To enable, press [720P I/O Converter], turning it on. To disable, press [720P I/O Converter], turning it off. 459