Sony XVS-7000 Users Guide - Page 427
Settings Relating to Device Connections, Setting the Control Mode for P-Bus, Devices
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 427 highlights
1 In the Engineering Setup >Panel >Prefs/Utility >Xpt Module Assign menu (7324.2), select the target button to set. 2 Press [Name]. 3 Enter a name of up to 8 characters in the keyboard window, and press [Enter]. Settings Relating to Device Connections Setting the Control Mode for P-Bus Devices In the group of the Engineering Setup >Panel >Device Interface menu (7325), select the protocol mode. Trigger: When a predetermined button is pressed, the action command assigned to that button is output to control an external device. Timeline: The external device is controlled as a keyframe effect controlled by the control panel. Assigning the Target Port to a Channel Selection Button You can assign an SIU serial port or a network port to the channel selection buttons (CH1 to CH12). This allows you to operate a device connected to the port using the specified channel selection button. For details about port settings, see "Configuring the Connection Port of External Devices" (page 478). 1 In the Engineering Setup >Panel >Device Interface menu (7325), press [Device Assign]. The Device Assign menu (7325.4) appears. 2 In the status area, select the target port to set. 3 In the group, select the button (DEV CH1 to DEV CH12) to which to assign the port. [DEV CH1] to [DEV CH12] correspond to the [CH1] to [CH12] channel selection buttons on the device control block. Notes • It is not possible to assign the same port to more than one button. The most recently set button is enabled. • A port configured with a P-Bus compatible device cannot be assigned to a button. 4 Repeat steps 2 and 3 as required to set other ports. 427