Sony XVS-7000 Users Guide - Page 202
Multi Program 2 Mode Settings, Other Operations, Assigning main/sub to switcher banks
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
For details, see "Setting the key preview configuration" (page 440). To assign sub bank outputs to output connectors Use the Engineering Setup >Switcher >Output >Output Assign menu (7333.1). You can assign a sub bank output signal to a switcher output connector number. For details, see "Assigning Output Signals" (page 456). Assigning main/sub to switcher banks For each switcher bank for which Multi Program 2 mode is selected, set whether the bank is dedicated main (Main), dedicated sub (Sub), or shared main and sub (Main&Sub). To assign main and sub to a single switcher bank 1 In the status area of the Engineering Setup >Panel >Config >MP2 Main/Sub Assign menu (7321.11), select the switcher bank. 2 In the group, select [Main&Sub]. To assign main and sub to two consecutive switcher banks This section describes assigning the first switcher bank to M/E-1 main (called the 1st row), and the second switcher bank to M/E-1 sub (called the 2nd row) as an example. 1 In the status area of the Engineering Setup >Panel >Config >MP2 Main/Sub Assign menu (7321.11), select the "1st Row" (M/E-1), then press [Main] in the group. 2 Press [Dual M/E Assign]. Two switcher bank rows are assigned as a single M/E. In this state, both the "1st Row" and "2nd Row" are set to main. 3 Select "2nd Row" and press [Sub] in the group. Notes • This cancels the shift/non-shift assignment set using [Dual M/E Assign] in standard mode. • It is not possible to assign combinations of [Main] and [Main&Sub], or [Sub] and [Main&Sub]. Image creation operation flow This section describes the operation of an M/E bank shared between main and sub as an example. To switch between main and sub, press the [MAIN] or [SUB] button on the cross-point pad of the cross-point control block. 1 On the cross-point control block, press the [MAIN] button in the cross-point pad to select main. If the [SUB] button is selected, press the button to deselect it. 2 Create the main bank video image. 3 Press the [SUB] button to select it, and press the [MAIN] button to deselect it. 4 Create the sub bank video image. On the sub bank, the utility 2 bus signal is assigned to background A, and the utility 3 bus signal is assigned to background B. Only keys 2 to 8 and standard wipe patterns can be used on the sub bank. For details, see "Differences Between Multi Program 2 Mode and Standard Mode" (page 205) and "Multi Program 2 Mode Restrictions" (page 206). 5 Press the [MAIN] button so that both the [MAIN] button and [SUB] button are selected. If both buttons are selected, the control panel shows the status of the main bank. 6 Execute a transition. Both main bank and sub bank video images are switched. Multi Program 2 Mode Settings (Other Operations) Assigning transition control block buttons to main/sub If you are using two switcher M/E banks dedicated to main bank and sub bank, you can make separate transition control block button assignments for the main bank and sub bank. Note When using one M/E bank as shared main and sub (Main&Sub), separate settings are not possible. This section describes the assignment of buttons on the left side of the transition control block or transition control block (simple type) as an example. To assign buttons on the right side of the transition control block (independent key transition execution section buttons), use the same procedure in the Engineering Setup >Panel >Config >Link/Program Button >Transition Module2 menu (7321.34). 202