Sony XVS-7000 Users Guide - Page 490
Serial Tally Settings, Deleting Parallel Tally, Configuring/Modifying Serial Tally
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 490 highlights
No. Parameter Adjustment 3 Type Tally type a) a) 1: R1, 2: G1, 3: R2, 4: G2, 5: R3, 6: G3, 7: R4, 8: G4, 9: R5, 10: G5, 11: R6, 12: G6, 13: R7, 14: G7, 15: R8, 16: G8 (R stands for Red Tally, and G for Green Tally) 7 Press [Execute]. Deleting Parallel Tally 1 In the Engineering Setup >Router/Tally >Parallel Tally menu (7366), select the parallel tally. 2 Press [Clear]. Serial Tally Settings You can configure the tally type, data size, and source address for two serial tally ports on a system interface unit (SIU). You can also specify a port number for a network connection to control tally information via a network. Note If using a network port, configuration of the SIU utility connector is required. For details, refer to the ICP-X7000 Installation Manual. Configuring/Modifying Serial Tally 1 In the of the Engineering Setup >Router/Tally >Serial Tally menu (7367), select the target port to set. 2 In the group, select the tally group. 3 In the group, select the tally types. Up to four tally types can be selected. Note The selectable tally types depend on the setting selected in step 2. 4 In the group, select the data size. 128 Bit: 128 bits 256 Bit: 256 bits 5 To configure a network port, select [Port]. Enter the network port number using the numeric keypad window, then press [Enter]. Note Correct operation may not occur, depending on the port. For the serial tally network port, port number "2020" is recommended for [Port1], and "2021" is recommended for [Port2]. For details, consult your Sony service or sales representative. 490