Sony XVS-7000 Users Guide - Page 178

Ping-Pong: When the playback stop point is reached, playback continues in the reverse direction until the playback start point, and then repeats. To play audio data Press [Audio], turning it on. For details about audio data, see "Frame memory audio data" (page 170). To change the playback speed Press [Variable Speed], turning it on, and set the following parameter. No. Parameter Adjustment 3 Speed Playback speed To cue up Press [Cue]. To move to the start of a clip Press [Rewind]. To move to the end of a clip Press [FF]. To set the playback start point To set the current position as the playback start point, press [Set] in the group. To set a different position, press the [Start] icon display in the status area, and enter a timecode value in the numeric keypad window. Pressing [Clear] in the group clears the set playback start point. To set the playback stop point To set the current position as the playback stop point, press [Set] in the group. To set a different position, press the [Stop] icon display in the status area, and enter a timecode value in the numeric keypad window. Pressing [Clear] in the group clears the set playback stop point. To change the current position Press the [Current] icon display in the status area, and enter a timecode value in the numeric keypad window. To delete regions outside the playback range (trimming) You can delete the region before the set playback start point and the region after the set playback stop point. Press [Trim], check the message, then press [Yes]. Note The following clip files cannot be trimmed. • A file being played back • A file recalled on a locked FM output • A file in a locked folder Playing a clip (device control block) You can play a clip recalled on an FM output, from the menu, using the device control block (trackball). For details about the buttons in the device control block (trackball), see "Device Control Block (Trackball)" (page 40) and "Controlling the Tape/Disk Transport" (page 286). Note The [FM1 CLIP] to [FM20 CLIP] buttons must be assigned to the channel selection buttons beforehand in the Setup menu (see page 411). 1 Press the [DEV] button. 2 Select the target frame memory clip (FM1 CLIP to FM20 CLIP) using the channel selection buttons. In pair mode, the channel selection buttons for main and sub are lit. 3 Press the [PLAY] button. The [PLAY] button is lit amber, and playback starts. To stop playback, press the [STOP], [SHTL], [JOG], [CUE], [REW], [FF], or [ALL STOP] button. To set the playback start point To make the current position the playback start point, press the [START TC] button. To set the playback stop point To make the current position the playback stop point, press the [STOP TC] button. To repeat playback (looping) Press the [FM LOOP] button. To control variable speed playback Press the [JOG], [SHTL], or [VAR] button, then turn the Z-ring. The image changes in the forward direction when you turn the Z-ring clockwise, and in the reverse direction when you turn it counterclockwise. When the [JOG] button is pressed: Playback is at a speed corresponding to the turning speed of the Z-ring. When the [SHTL] button is pressed: Playback is at a speed corresponding to the angle of the Z-ring. When the [VAR] button is pressed: Playback is at a speed in the range -1 to +3 times normal speed corresponding to the angle of the Z-ring. 178