Sony XVS-7000 Users Guide - Page 429
Configuring Settings Relating to, Effects, Setting Source Names and, Destination Names, link function
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 429 highlights
Configuring Settings Relating to Effects Setting functions used in keyframe effect operations In the Engineering Setup >Panel >Operation menu (7326), press [Effect Mode] to open the Effect Mode menu (7326.2). Configure each function, as required. Setting the first keyframe state when recalling an effect In the group, select one of the following. Recall: The first keyframe is not reproduced. Recall&Rewind: The first keyframe is reproduced. Disabling the [EDIT ENBL] button when recalling an effect Press [Edit Enable Auto Off], turning it on. If an effect is recalled when the [EDIT ENBL] button is lit, the [EDIT ENBL] button is automatically disabled. Inserting the first keyframe automatically Press [1st KF Auto Insert], turning it on. When an empty register is recalled, the state at that point is automatically inserted as the first keyframe. Setting the operation mode when the [RUN] button is pressed during keyframe effect execution In the group, select one of the following. Continue: Continue the effect. Cancel: Cancel the effect, and return to the previous state. Setting auto save for an effect Press [Effect Auto Save], turning it on. When an effect is recalled after effect editing, the edited effect is automatically saved. Setting the default value of keyframe duration Press [Default KF Duration], then enter the default value using the numeric keypad window. Setting the first keyframe when rewind is executed For P-Bus, GPI, DDR/VTR, and macro timeline operations, you can set to execute the first keyframe when rewind is executed. Note When enabled and an effect is executed by pressing the [RUN] button, the first keyframe action is not executed. In the group of the Engineering Setup >Panel >Operation >Effect Mode menu (7326.2), select the target to set. GPI: GPI timeline P-Bus: P-Bus timeline DDR/VTR: VTR/disk recorder timeline Macro: Macro timeline Setting Source Names and Destination Names You set the source and destination names to use in the control panel. Note It is necessary to set the group number of the S-Bus description name or NS-Bus alias name beforehand (see page 485). 1 In the group of the Engineering Setup >Panel >Operation menu (7326), select the name to use. Sw'er Local: Source name set on the switcher, and fixed bus name S-Bus Descript: Description name set in the router (S-Bus only) S-Bus Type+Num: Type+Num name set in the router (S-Bus only) NS-Bus Alias: Alias name set in the system controller (NS-Bus only) 2 In the group, select the display method. Auto: Four characters per line, up to four lines 2 Characters: First two characters displayed on one line 4 Characters: First four characters displayed on one line Notes • When [S-Bus Type+Num] is selected in step 1, the first eight characters are displayed on two lines. The display method cannot be set. • Line breaks in names are valid only when [Auto] is selected. • Up to two lines are displayed when the display mode (see page 436) is set to split display. Enabling the description name/alias name link function When the link function is enabled, you can replace a source name set on the switcher with an S-Bus description 429