Sony XVS-7000 Users Guide - Page 396
Enabling Passage of 59.94 2×, Format Signals on an AUX Bus, Switching the Input Reference, Signal
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 396 highlights
3 In the group, select the color gamut. 709: BT.709 color gamut 2020: BT.2020 color gamut 4 Press [Execute]. 5 Check the message, then press [Yes]. Enabling Passage of 59.94 (2×) Format Signals on an AUX Bus When the signal format is 1080i/59.94 or 1080PsF/29.97, passage of 59.94 (2×) format signals can be enabled on the AUX bus. The signal format can be set for each group of four outputs. Notes • On the XVS-9000, 59.94 (2×) format is not available. • You can output in 59.94 (2×) format only when the following signals are assigned. AUX1 to 48, Preset, Edit Preview outputs 1 In the Engineering Setup >System >Format menu (7313), press [AUX Signal Format]. The AUX Signal Format menu (7313.5) appears. 2 Select the target output to set. Select one of the four target outputs to set. 3 In the group, press [59.94Hz (2×)]. To block passage of 59.94 (2×) signals on the AUX bus, select [59.94Hz] or [29.97Hz]. 4 Press [Execute]. 5 Check the message, then press [Yes]. Switching the Input Reference Signal Notes • SWR1 and DME1 (and SWR2 and DME3) input reference signal settings are linked. • The input reference signal settings on the MKS-X7700 and MKS-X2700 System Interface Units are the same as the master panel settings. 1 In the Engineering Setup >System >Format menu (7313), select the target device to set. 2 In the group, select one of the following. Tri Sync: HD tri-level sync BB: Black burst or sync 3 Press [Execute]. 4 Check the message, then press [Yes]. The following table shows the relationship between signal format and the supported input reference signal frequency. Signal format 3840×2160P/ 59.94 2SI 3840×2160P/ 59.94 SQD 3840×2160PsF/ 29.97 SQD 1080P/59.94 1080PsF/29.97 1080i/59.94 3840×2160P/50 2SI 3840×2160P/50 SQD 3840×2160PsF/ 25 SQD 1080P/50 1080PsF/25 1080i/50 3840×2160PsF/ 24 SQD 1080PsF/24 3840×2160PsF/ 23.98 SQD 1080PsF/23.98 720P/59.94 720P/50 Input reference signal Tri BB Sync 59.94 Black Burst 59.94 50 Black Burst 50 48 - 47.952 - 59.94 - Black Burst 59.94 Black Burst 50 Sync 59.94 Sync 50 Sync 59.94 Sync 50 Adding a Payload ID When the signal format is 3840×2160PsF, 1080PsF, 1080i, or 720P, a payload ID can be added to the output signal. To add a payload ID, in the Engineering Setup >System >Format menu (7313), press [Payload ID], turning it on. 396