Sony XVS-7000 Users Guide - Page 50

The 1st row and 2nd row can select different destinations (second delegation mode) by pressing the [2ND DELG] button on the cross-point pad, turning it on. Name 1st row 2nd row 3rd row 4th row Description When the [2ND DELG] button is lit: Selects a destination to assign in the 3rd row. When the [2ND DELG] button is not lit: • Selects a destination to assign in the 3rd row and 4th row. • Selects a destination on the unshifted state of a delegation button in the 1st row. When the [2ND DELG] button is lit: Selects a destination to assign in the 4th row. When the [2ND DELG] button is not lit: • Selects a destination to assign in the 3rd row and 4th row. • Selects a destination on the shifted state of a delegation button in the 2nd row. When the [2ND DELG] button is lit: Selects a source for the destination selected in the 1st row. When the [2ND DELG] button is not lit: • Selects a source for the destination selected in the 1st row or 2nd row. • You can select a source on the shifted state of a button while pressing the [SHIFT] button. When the [2ND DELG] button is lit: Selects a source for the destination selected in the 2nd row. When the [2ND DELG] button is not lit: Selects a source on the shifted state for the destination selected in the 1st row or 2nd row. SHIFT button The [SHIFT] button function is assigned to the button on the right-hand end, and is used to toggle between the shifted and unshifted states of the button row. The operation of the [SHIFT] button in second delegation mode can be set to one of the following modes in the Setup menu. • The shifted state is selected while the button is pressed (hold mode). • Every time the button is pressed, it toggles between shifted and unshifted states (lock mode). You can also disable the [SHIFT] button function for the 3rd row/4th row cross-point buttons. For details, see "Setting the Router Operation Mode" (page 417). Delegation button/cross-point button numbers The button numbers are labeled on the delegation/crosspoint buttons. The button numbers are the same as for AUX bus control block (AUX bus operation mode). However, button numbers 65 to 70 are unavailable for 1st row/2nd row delegation buttons. For details, see "Button numbers in the AUX bus control block (AUX bus operation mode)" (page 80). b Display Six types of display mode can be selected, according to the information to display. The display mode is switched using the display mode buttons on the cross-point pad. The following information can be shown on the display. • Settings of buttons on the 1st row to 4th row (destination name, source name) • Names of sources selected on each destination for the delegation buttons in the 1st row and 2nd row Notes • When the [SHIFT] button function is set, "SHFT" appears on the display. When the shifted state is selected, "SHFT" is highlighted in reverse video, and the button information also toggles to show the shifted display. • When the [DEST DISP MODE] button is pressed, turning it off, the 1st row and 2nd row information shown on the display toggles to the source names selected for the destination. The information shown in each display mode is configured in the Setup menu. The display can also be subdivided (top and bottom) to display two pieces of information. For details, see "Setting the Display Mode of the CrossPoint Control Block/AUX Bus Control Block" (page 436). c Cross-point indicators Not used in router operation mode. d Cross-point pad For details about the cross-point pad, see "Cross-point pad" (page 48) in AUX bus operation mode. Menu Panel The menu panel is used for menu operations. 50