Sony XVS-7000 Users Guide - Page 328

Attributes Cross-point hold Key disable Effect dissolve Auto transition Clip auto play Yes: Available, No: Not available Region M/E-1, M/E-2, M/E-3, M/E-4, M/E-5, PGM/PST Yes Yes Yes Yes No User1 to DME ch1 8 to ch4 Yes Yes No No Yes Yes No No Yes No Attribute display You can check the attributes added to a snapshot in the Snapshot menu (see page 334). Snapshot Operations (Numeric Keypad Control Block) Saving and Recalling Snapshots SNAPSHOT button Display AUTO TRANS button EFF DISS button UNDO button Temporary attributes When recalling a snapshot, you can temporarily enable attributes distinct from the attributes set for each register. These are called "temporary attributes." You set temporary attributes when recalling a snapshot. Bus override If you recall a snapshot while holding down an A or B bus button, the selection of the signal on the A or B bus does not change when the snapshot is recalled. This function is called "bus override." This function is effective when cross-point hold is not set, and you want to temporarily maintain the cross-point setting. When cross-point hold is set, bus override operation is not necessary. STORE button RCALL button STORE STATS button Region selection buttons Numeric keypad buttons Numeric keypad control block Saving a snapshot 1 Set the state you want to save as a snapshot. 2 In the numeric keypad control block, press the [SNAPSHOT] button. The control block switches to snapshot operation mode, and the [SNAPSHOT] button and [RCALL] button light amber. 3 Use the region selection buttons to select the target region of the operation. You can select more than one button. The following region selection buttons can be operated for snapshots. 328