Sony XVS-7000 Users Guide - Page 439
Switcher Setup, Settings Relating to Switcher Configuration, Settings Relating
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 439 highlights
Switcher Setup 19 Chapter Settings Relating to Switcher Configuration Adjusting the Reference Phase This adjusts the switcher internal reference phase. In the Engineering Setup >Switcher >Config menu (7331), set the following parameter. No. Parameter Adjustment 3 Phase Switcher internal reference phase Specifying the Video Switching Timing 1 In the Engineering Setup >Switcher >Config menu (7331), press [Switching Timing]. The Switching Timing menu (7331.8) appears. 2 Select one of the following. Any: Not specified Field 1: Field 1 Field 2: Field 2 Note Fixed to [Field 1] when the signal format is 3840×2160PsF or 1080PsF, and fixed to [Any] when 720P. Setting the Operation Mode This sets the output signal configuration for each bank. 1 Open the Engineering Setup >Switcher >Config menu (7331). 2 In the status area, select the target switcher bank to set. 3 In the group, select the operation mode. Standard: Standard mode Multi Program: Multi-program mode DSK: DSK mode (PGM/PST only) About the operation mode • Standard mode: Fix the output signal configuration for the maximum of four outputs (Out1 to 4) of the M/E and PGM/PST banks as follows. - Out1: Program output - Out2: Preview output - Out3: Clean output - Out4: Key preview output 1) • Multi-program mode: Increase the number of M/E or PGM/PST program systems, and assign one of the following to up to six outputs (Out1 to 6) (M/E Output Assign). - Program outputs 1 to 4 - Preview output - Key preview outputs 1) 1 and 2 - Clean output Further, you can change the combination of signals from which the program output is configured (PGM Config). • DSK mode: Treats PGM/PSTs as DSKs by assigning one of the Out1 to Out6 program outputs of M/E-1 to M/E-5 to the background. You can change the signals that make up the program output and key preview output 1) using PGM Config and K-PVW Config. 1) For the key preview output, you can select either video mode (background and key) or key mode (key only), and select the background and key (KPVW Config). Notes • When Multi-program mode is selected, two or more transition type selection buttons may be lit on the transition control block. Also, more than one group button may be selected in the Misc >Transition menu of each M/E and PGM/PST bank. • In 4K format, up to four outputs (Out1 to Out4) are available on each switcher bank in multi-program mode. • In 4K format, the outputs in DSK mode have the following configuration. - Out1: Program output 1 439