Sony XVS-7000 Users Guide - Page 272

Applying Special Effects (Other Effects) Background Settings You can add a color to the background or input an external signal to use as the background of the image. Setting the background 1 Open the DME >Input/Output >Bkgd menu (4161). 2 Press [Bkgd], turning it on. 3 In the group, select one of the following. Flat Color: Single color Mix Color: Mix color signal set in the DME >Edge >Color Mix menu (4117) (see page 240) Ext Video: External video signal input from Ext In Notes • Only [Mix Color] or [Ext Video] can be used between the Background, Flex Shadow (see page 235), Trail (see page 262), and Wind (see page 265) effects. If [Mix Color] or [Ext Video] is selected for one of these effects, the [Mix Color] or [Ext Video] for the other effects is disabled, and [Flat Color] is selected in its place. • When executing a 4-channel combination, [Mix Color] and [Ext Video] cannot be selected. 4 When [Flat Color] is selected in step 3, set the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue Separate Sides Settings This applies different video signals and key signals to the front and back of the image. Setting Separate Sides 1 Open the DME >Input/Output >Video/Key menu (4162). 2 Press [Separate Side], turning it on. Separate Sides is enabled. If the video and key signals currently being output to the monitor are the front side, you can select the Front signals. If they are the back side, you can select the Back signals. Video and key signals are selected using the cross-point control blocks of each M/E bank or the PGM/PST bank. Invert Settings This effect inverts the input video signal and/or key signal horizontally or vertically. You can make separate settings for the front and back. Applying the Invert effect 1 Open the DME >Input/Output >Video/Key menu (4162). 2 Select the invert direction in the group for the front input signal and in the group for the back input signal. H Invert: Invert video and key signals horizontally. V Invert: Invert video and key signals vertically. Key Density Settings You can adjust the key density for the key signal input to the DME. Setting the key density 1 Open the DME >Input/Output >Video/Key menu (4162). 2 Press [Key Density], turning it on. 3 Set the following parameter. No. Parameter Adjustment 1 Key Density Key density Key Source Selection You can select either the key signals received from the switcher or the key signals generated in the DME for application to the front and back of the image. 272