Sony XVS-7000 Users Guide - Page 103
Selecting Independent Key, Transition Type, type Flexi Pad control block, type menu
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 103 highlights
To insert or remove the key gradually with a mix or wipe, press the [AUTO TRANS] button for the corresponding key or operate the fader lever. Pressing the [AUTO TRANS] button executes the transition at the preset transition rate. To insert/remove the key instantaneously, press the [KEY ON] button for the corresponding key. Note You can also set the key delegation button for operation by the fader lever. For details, see "Setting the Buttons and Fader Levers on the Key Fader Control Block" (page 408). To check the independent key transition type The specified independent key transition type is displayed in the independent key transition display section in the transition control block or independent key transition control block. The transition type for keys assigned to the key delegation buttons are shown on the display in the key fader control block. Notes • The transition types are indicated by the letter "M" (mix), "W" (wipe), "D" (DME wipe), and "C" (cut). • The transition type is not displayed when the transition rate display is set to timecode display mode. Selecting Independent Key Transition Type There are two ways of setting the transition type: using the Flexi Pad control block or using the Transition/Video Process menu for the target key on the M/E or PGM/PST bank. You can also set the transition type using independent key transition operations on the key fader control block (see page 102). When the independent key transition mode is set to [Independ] in the group of the Engineering Setup >Switcher >Transition menu (7334), you can select the transition type used when inserting and removing a key. Setting the independent key transition type (menu) This section describes setting the transition type for key 1 on the M/E-1 bank as an example. 1 Open the M/E-1 >Key1 >Transition/Video Process menu (1117). 2 Select the transition type in the group. If the independent key transition mode is set to [Independ], select the transition type for key insertion in the group and the transition type for key removal in the group. Setting the independent key transition type (Flexi Pad control block) If the independent key transition mode is set to [Independ], setting the transition type while a key is not inserted will set the transition type for key insertion, and setting the transition type while a key is inserted will set the transition type for key removal. 1 In the Flexi Pad control block of the target switcher bank, press the [KEY] button. This switches the memory recall section to independent key mode. 2 Select the target key. Press one of the [KEY1] to [KEY8] buttons, turning it on. 3 Set the transition type. Press the [MIX], [WIPE], or [DME WIPE] button, turning it on. Setting the Independent Key Transition Rate There are two ways of setting the transition rate: entering a value using the numeric keypad control block or using the Transition/Video Process menu for target key on the M/E or PGM/PST bank. You can also display the transition rate, independent key transition rate, and fade-to-black transition rate for each bank, and change the settings (see page 189). When the independent key transition mode is set to [Independ] in the group of the Engineering Setup >Switcher >Transition menu (7334), you can select the transition type rate when inserting and removing a key. 103