Sony XVS-7000 Users Guide - Page 118
Setting key drop mode, Matte color mixing for key edge fill, To set the key fill/key source position
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 118 highlights
8 To make separate fine adjustments to the positions of the left, right, top, and bottom of the key source, select [Fine Key] and set the following parameters. Parameter group [1/2] No. Parameter Adjustment 1 Top Key top edge position 2 Left Key left edge position 3 Right Key right edge position 4 Bottom Key bottom edge position Parameter group [2/2] No. Parameter Adjustment 1 H Phase Key horizontal position 2 V Phase Key vertical position Notes • When emboss is selected for the edge type, [Fine Key] cannot be selected. • When normal, drop border, or shadow is selected for the edge type, enabling [Fine Key] enables [Key Drop]. • When applying a border to the key edge, enabling the [Fine Key] function halves the border width setting range. Setting key drop mode 1 In the M/E-1 >Key1 >Edge menu (1112), press [Key Delay Mode]. The Key Delay Mode menu (1112.4) appears. 2 In the group, press [Key Drop] to set key drop mode. When key drop on mode is set, [Key Drop] is lit. When key drop off mode is set, [Key Drop] is not lit. To set the key fill/key source position Press [8H Mode] to switch between 8H mode and 4H mode. When 8H mode is set, [8H Mode] is lit. When 4H mode is set, [8H Mode] is not lit. To fix key fill/key source to key drop off mode Enable frame delay mode. In the group, press [Frame Delay], turning it on. Notes • The resizer function is used in frame delay mode. The frame delay mode setting is enabled only when the conditions for use of the resizer are satisfied. • When using dual resizer effects, the frame delay mode setting is disabled on the two target keys. • When the frame delay mode setting is enabled, the video has a one-frame delay. Matte color mixing for key edge fill If [Matte] is selected for the edge fill of a border, drop border, or shadow, you can create a combination of color 1 and color 2 using a wipe pattern generated by the dedicated pattern generator. 1 In the group of the M/E-1 >Key1 >Edge menu (1112), select [Matte] and press [Matte Adjust]. The Matte Adjust menu (1112.1) appears. 2 In the group, press [Mix Color]. 3 Set the following parameters. No. Parameter Adjustment 1 Size Pattern size 2 Soft Degree of softness of pattern edge 3 Pattern Pattern number a) a) The patterns are the same as standard wipe patterns 1 to 24. You can also make a pattern selection by pressing [Mix Pattern Select] in the Matte Adjust menu to display the Mix Ptn Select menu (1112.2). Press the desired pattern (1 to 24) to select it, and set the [Size] and [Soft] parameters. 4 When adjusting color 1 and 2, select [Color 1] and [Color 2], respectively, then adjust the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue 5 Set pattern modifiers, as required. When selecting [Position] and setting the pattern position No. Parameter Adjustment 1 Position H Horizontal position a) 2 Position V Vertical position a) a) See page 145. 118