Sony XVS-7000 Users Guide - Page 80

Cross-point control block button numbers SHIFT button 1, 2, 3, 4, ... 36, 37, 38, 39, ... (first numbers) (second numbers) ..., 33, 34, 35 ..., 68, 69, 70 SHIFT button On the M/E and PGM/PST banks, each cross-point button has two button numbers, and you use the [SHIFT] button to switch between these numbers. In the case of a 36-button layout, the button numbers are as follows. Button Number when the Number when the shift button is not shift button is pressed (unshifted pressed (shifted state) state) From left side to 1 to 35 35th 36 to 70 The rightmost (36th) button is used as the [SHIFT] button. When selecting the signals of button numbers 1 to 35, press the corresponding cross-point button number. When selecting the signals of button numbers 36 to 70, press the [SHIFT] button and the corresponding cross-point button number. Notes • The [SHIFT] button functions in the mode (hold/lock) set in the Setup menu. You can also disable the [SHIFT] button function. For details, see "Setting the [SHIFT] button operation mode" (page 414). • The [SHIFT ALL] button assigned to the cross-point pad is enabled, even if the [SHIFT] button use is not set. In this case, the button numbers are 1 to 36 in the unshifted state, and 37 to 72 in the shifted state. • You can use the rightmost button (36th) as a [SIDE FLAG] button. In this case, the [SHIFT] button moves one position to the left to number 35, and the button numbers are offset by one. For details about the [SIDE FLAG] button, see "Assigning the [SIDE FLAG] Button" (page 416). Button numbers in the AUX bus control block (AUX bus operation mode) The 1st row and 2nd row are used as bus selection delegation button rows, and the 3rd row and 4th row are used as signal selection cross-point button rows. The button numbers vary depending on the state of the [2ND DELG] button (lit/unlit) in the cross-point pad. When the [2ND DELG] button is lit (second delegation mode) The bus selected by the delegation buttons in the 1st row is assigned to the 3rd row, and the bus selected by the delegation buttons in the 2nd row is assigned to the 4th row. In the case of a 36-button layout, the button numbers are as follows. Button Number when the Number when the shift button is not shift button is pressed (unshifted pressed (shifted state) state) From left side to 1 to 35 35th 36 to 70 The rightmost (36th) button is used as the [SHIFT] button. When selecting the bus/signals of button numbers 1 to 35, press the corresponding cross-point button number. When selecting the bus/signals of button numbers 36 to 70, press the [SHIFT] button and the corresponding cross-point button number. Note The [SHIFT] button functions in the mode (hold/lock) set in the Setup menu. You can also disable the [SHIFT] button function for the 3rd row/4th row cross-point buttons. 80