Sony XVS-7000 Users Guide - Page 350

4 If required, set auto insert mode (see page 349). 5 Create the events (carry out the control panel operations to be registered as events in the macro). You can also include pause events (see page 352). For details about the events that can be registered, see "Events" (page 345). When auto insert mode is enabled, the event is registered automatically. When auto insert mode is disabled, press the [INS] button in the utility/shotbox control block to register events. Notes • During macro editing, if you press any of the mode selection buttons in the numeric keypad control block other than the [MCRO] button, the executed operation is also registered as an event. In this case, the [MCRO] button remains lit red. • Even during macro editing, you can switch and operate the memory recall buttons using the mode selection buttons in the utility/shotbox control block. The following buttons can also be used for keyframe operations. [EFF LOOP], [STOP NEXT KF], [NORM], [REV], [NORM/REV], [REWIND], [RUN] • For details about the operation when a button with a macro attachment is pressed during macro editing, see "To merge a macro set in a macro attachment" (page 350). 6 Repeat steps 4 and 5 to register the required events in the macro. This registers the events in the macro, in the order the operations were carried out on the control panel. 7 In the numeric keypad control block, press the [STORE] button. Macro editing mode finishes, and the [MCRO] button and [STORE] button in the numeric keypad control block light amber. The memory recall buttons in the utility/shotbox control block switch to the assignments for keyframe editing. 8 Use the numeric keypad to enter the number (1 to 250) of the register in which you want to save. For details about selecting a register, see "Register selection in the numeric keypad control block" (page 305). 9 Press the [ENTER] button. The created macro is saved in the register, and the [STORE STATS] button and [RCALL] button are lit amber. The display shows the saved register number. Note While carrying out macro editing in the numeric keypad control block and utility/shotbox control block, no macro operation other than macro recalling is possible in other control blocks. To cancel the saving of a macro While the [STORE STATS] button is lit amber, press and hold the [STORE STATS] button and press the [UNDO] button. To merge a macro set in a macro attachment While creating/editing a macro, if you press a button for which a macro attachment is set, the macro in the register assigned to the button is recalled, and the following occurs. • When auto insert mode is enabled, it is merged with the macro being edited. However, the macro assigned to the button is not executed. • When auto insert mode is disabled, it is stored in the paste buffer. Pressing the [PASTE] button in the utility/ shotbox control block merges it with the macro being edited. Specifying an edit point 1 In the numeric keypad control block, press the [MCRO] button. The control block switches to macro operation mode, and the [MCRO] button and [RCALL] button light amber. 2 Recall the target register for operation (see page 349). 3 Holding down the [MCRO] button, press the [STORE] button. This switches the numeric keypad control block to macro editing mode. The [STORE] button blinks red, and the [MCRO] button changes color to red. 4 Press the [KF MCRO EDIT] button in the utility/ shotbox control block. Selecting keyframe/macro editing mode in the utility/ shotbox control block when the numeric keypad control block is in macro editing mode switches the memory recall buttons to the assignments for macro editing, and the [EDIT ENBL] button turns on red. 350