Sony XVS-7000 Users Guide - Page 257

2 Set the following parameters. No. Parameter Adjustment 1 Radius Radius of turn part 2 Offset Amount of turn 3 Angle Angle of turn To set the input signal for the back page 1 In the group, select the signal input for the back page. Self: Use the same signal as the front page. Flat: Use a single color. Hue Rotation: Gradually vary the hue. 2nd Ch: Use the 2nd channel video signal. To select 2nd Ch, you must select the DME for the second channel beforehand. For details, see "DME Effects for Keys" (page 121) and "DME Effects for Keys" (page 127). 2 Set the following parameters, according to the selected input signal. When [Flat] is selected No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue When [Hue Rotation] is selected No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Speed Speed at which the hue changes Note If Page Turn is used on one channel when the signal format is 3840×2160P 2SI or 1080P (for example, when the input is a title), parts of the back page other than the title appear as black. Roll Settings There are four modes: H&V, H, V, and Off. You can select the turn position, the radius of the turned portion, the amount and angle of turning, and the input video for the front and back pages. Applying the Roll effect Open the Non Linear >Roll menu (4141.20). The items and parameters displayed in the Roll menu are the same as for the Page Turn menu (see page 256). Note If Roll is used on one channel when the signal format is 3840×2160P 2SI or 1080P (for example, when the input is a title), parts of the back page other than the title appear as black. Cylinder Settings You can set the degree of winding onto the cylinder, the radius, the horizontal position of the wound image, and front and back side output for the image. Applying the Cylinder effect In the Non Linear >Cylinder menu (4141.21), set the following parameters. No. Parameter Adjustment 1 Radius Degree to which image is wound onto the cylinder 2 Min R Radius of the cylinder 3 Offset Horizontal position of the image wound onto cylinder To set the input signal for the back image The operation is the same as for the group of the Page Turn menu (4141.19) (see page 257). Note If Cylinder is used on one channel when the signal format is 1080P (for example, when the input is a title), parts of the rear surface other than the title appear as black. Sphere Settings You can set the degree of wrapping onto the sphere, the radius, the horizontal position of the wrapped image, and front and back side output for the image. Note You cannot monitor the part of a rotating sphere that corresponds to the axis on the monitor screen. Applying the Sphere effect Open the Non Linear >Sphere menu (4141.22). The items and parameters displayed in the Sphere menu are the same as for the Cylinder menu (see page 257). 257