Sony XVS-7000 Users Guide - Page 331
Saving and Recalling Snapshots, Saving a snapshot
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 331 highlights
Bank number Bank 8 Bank 9 Bank 10 Bank 11 Bank 12 Register number 80 to 89 90 to 99 100 to 109 110 to 119 120 to 129 Bank number Bank 21 Bank 22 Bank 23 Bank 24 Bank 25 Register number 210 to 219 220 to 229 230 to 239 240 to 249 250 Notes • The banks and number of registers that can be selected vary depending on the function. • A register number is not assigned to the bottom left button of bank 0 by default. You can assign a register number in the Setup menu. For details, see "Setting Flexi Pad Control Block Button Display and Operation" (page 430). Bank and register selection in the Flexi Pad control block Select the bank corresponding to the target register using the bank selection buttons. To select bank 0: Press the [BANK0] button. To select bank 1: Press the [BANK1] button. To select bank 2: Press the [BANK2] button. To select bank 0 to 25: Press the [BANK SEL] button, and enter the desired bank with the numeric keypad buttons in the memory recall section. When a bank is selected, the memory recall section changes to display the register numbers. The register name is displayed on buttons for registers with registered data. The button color varies as follows, according to the register state. Gray characters on black: Register not containing saved data White characters on dark blue: Register containing saved data Lit orange: Last recalled register You can switch to the register display of the previous or next bank number using the [PREV BANK] button or [NEXT BANK] button. Press the button for the target register to select it, turning it on orange. The selected bank and register number are displayed on the top right button in the memory recall section. Saving and Recalling Snapshots This section describes operation of snapshots on M/E-1 bank as an example. Saving a snapshot 1 In the M/E-1 bank, make the settings for the state you want to save as a snapshot. 2 In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button. This switches the memory recall section to snapshot operation mode. The last recalled bank is displayed on the M/E-1 bank. 3 Select the target bank for operation using the bank selection buttons. Select from bank 0 to 9 (register number 1 to 99) for the snapshot. For details about bank selection, see "Bank and register selection in the Flexi Pad control block" (page 331). 4 To add an attribute (see page 327), press and hold the [SNAPSHOT] button, and press the following button in the memory recall section, turning it on. Attribute Effect dissolve Auto transition Button [EFF DISS] button [AUTO TRANS] button Note In the Flexi Pad control block, it is not possible to add cross-point hold attributes. When adding attributes, use the menu (see page 333). 5 Still holding down the [SNAPSHOT] button from step 4, press the save destination register button. The selected button is lit orange, and the snapshot is saved. Note If you press a button in which a snapshot is already saved, the existing contents of the register will be overwritten. Recalling a snapshot Note If a switcher bank region is not assigned to a region selection button in the numeric keypad control block, the Flexi Pad control block cannot be used to recall a snapshot. 331