Sony XVS-7000 Users Guide - Page 142
Dust mix, Main/sub modifier link, Combining two patterns, Full link mode
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
• A value of 0.00 corresponds to the start of the transition, and a value of 100.00 corresponds to the end of the transition. • A negative Start value signifies that the main and sub patterns are already mixing when the transition starts. • An End value of 100.00 or more signifies that the main and sub patterns are still mixing when the transition ends. • If the Start and End values are the same, the main and sub patterns are interchanged instantaneously at a specified point in the transition. • If the End value is less than the Start value, the transition changes from the sub pattern to the main pattern. Dust mix You can apply a diamond dust wipe to a selected pattern. You can also apply the diamond dust wipe effect to the pattern resulting from a pattern mix (see page 143). When the pattern mix function is disabled, enabling dust mix mixes the main pattern and the diamond dust pattern. This state is the same as a pattern mix when the diamond dust pattern is selected for the sub pattern. Note When a random/diamond dust wipe (pattern numbers 270 to 274) is selected, the dust mix function is not available. Main/sub modifier link When carrying out a pattern mix, it is possible to link the modifier settings for the main pattern and sub pattern. There are two type of link mode, as follows. Full link mode In this mode, all modifier settings are the same for the main pattern and sub pattern. Changing the modifier settings for one pattern automatically changes the settings for the other. Semi link mode Only the parameter settings of the modifiers are linked. The modifier enable/disable settings are not linked. When the parameter values of the same modifiers for the main pattern and sub pattern are different and link mode is selected, changing the value of the parameter for one pattern also changes the value of the parameter for the other pattern to maintain the same difference between the two. Note When executing a wipe transition using a pattern mix, it is recommended that you set the modifier link function to full link mode. If the modifier link function is disabled or semi link mode is selected, the desired image may not be obtained at the start or end of the transition. Combining two patterns In the M/E-1 >Wipe >Main Pattern menu (1151), select a main pattern, then use the following procedure. 1 Open the M/E-1 >Wipe >Sub Pattern menu (1153). 2 Press the button for the desired wipe pattern group and then press the desired sub pattern to select it. Some patterns may not be available for selection, depending on the selected main pattern. Yes: Available, No: Not available Main pattern Sub pattern Standard Enhanced Rotary Mosaic Random/ diamond dust Standard Yes Yes No Yes Yes Enhanced Yes Yes No Yes Yes Rotary No No No No No Mosaic Yes Yes No No Yes Random/ Yes diamond dust Yes No Yes No 3 Open the M/E-1 >Wipe >Pattern Mix menu (1152). 4 In the group, select the type of pattern mix. Mix: Mix +Nam: Positive NAM −Nam: Negative NAM Morphing: Morphing 5 Depending on the selection in step 4, set the following parameters. When mix, positive NAM, or negative NAM is selected No. Parameter Adjustment 1 Mix Ratio Proportion of sub pattern relative to the main pattern When morphing is selected No. Parameter Adjustment 2 Start Point in transition at which main pattern is at 100% 3 End Point in transition at which sub pattern is at 100% 6 In the group, configure the main/ sub modifier link. Full: Full link mode Semi: Semi link mode 142