Sony XVS-7000 Users Guide - Page 413
Cross-Point Settings, Creating Cross-Point Assign Tables
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 413 highlights
Cross-Point Settings Creating Cross-Point Assign Tables You can create a "main" table and up to 14 other tables (table 1 to table 14) as cross-point assign tables. However, you can only carry out assignment of video and key combinations in the main table. Creating the main table In the main table, a pair consisting of a video signal and a key signal is assigned to each button number. You can also assign the same signal to another button number to duplicate the assignment. You can also delete currently assigned signals. Note The video/key pair numbers are fixed for the following button numbers in tables 1 to 14. Button number 281 to 286 291 to 296 V/K pair number 211, 221, 231, 241, 251, 261 216, 226, 236, 246, 256, 266 The re-entry video/key numbers are set as the pair numbers by default. Use the defaults as-is, since changing the settings will make it impossible to select the correct signals. 1 In the Engineering Setup >Panel >Xpt Assign menu (7322) or the Engineering Setup >Panel >Xpt Assign >Table Button Assign menu (7322.1), press [Main, V/K Pair Assign]. The Main, V/K Pair Assign menu (7322.5) appears. The left side of the status area shows the video and key signal names currently assigned in the main table, and the source numbers. When the shift button is pressed, the number field is distinguished by color. The right side of the status area shows a list of source numbers and assignable signals. 2 Select the target button number to set. No. Parameter Adjustment 1 V/K Pair No Selection of video and key pair number 3 In the group, select the target signal to set. Video: Set video signals. Key: Set key signals. [Video] and [Key] can also be selected at the same time. [Video] and [Key] cannot be deselected at the same time. One or the other is always selected. 4 Select the signal to assign. No. Parameter Adjustment 3 Source No Selection of signal to assign 5 In the group, select one of the following. Set: Delete the signal currently assigned to the selected button number and make a new assignment. Insert: Move the signal currently assigned to the selected button number to the next number, and make a new assignment. To inhibit operation of buttons Select the target button number to set, and press [Inhibit]. To delete a signal assigned to a button Select the button number, and press [Delete] in the group. The signals assigned to numbers following the selected button number move up in sequence. To return the table settings to the defaults Press [Default Recall], check the message, then press [Yes]. Creating tables 1 to 14 You create tables 1 to 14 in the same way as when creating the main table, and you can assign the same signal to more than one button number, or delete currently assigned signals. However, assignment of video and key combinations as a pair is not possible. 1 In the Engineering Setup >Panel >Xpt Assign menu (7322), press [Table Button Assign]. The Table Button Assign menu (7322.1) appears. The target table number to set appears in the upper left of the status area. The left side of the status area shows the cross-point button numbers, video and key pair numbers, video signal source names and source numbers, and key signal source names and source numbers. When the shift button is pressed, the number field is distinguished by color. The right side of the status area shows the video and key pair numbers, and the names of video signals and key signals set in the main table. 413