Sony XVS-7000 Users Guide - Page 366

are enabled. Macro attachments are enabled/disabled using the following buttons. Macro attachment location Button M/E and PGM/ Press [MACRO ATTACH ENABLE] on the PST banks cross-point pad of the cross-point control block. Other than M/E and PGM/PST banks Press the following buttons assigned with the "Macro Attachment Enbl" utility command. • User preference buttons in the menu panel • Memory recall buttons in the utility/ shotbox control block • Cross-point buttons of the cross-point control block (utility/shotbox mode) You can set to permanently enable or disable macro attachments without using buttons. For details, see "Setting the Macro Operation Mode" (page 432). Executing a macro assigned to a button 1 Depending on the location of the button you want to execute, press the [MACRO ATTACH ENABLE] button (or button assigned with the "Macro Attachment Enbl" command), turning it on. If using the [MACRO ATTACH ENABLE] button on the cross-point pad or a memory recall button in the utility/shotbox control block, press it, turning it on orange. 2 Press the button with a set macro attachment. This recalls the macro register assigned to the button, and the macro is executed as follows, according to the operation mode. Pre macro mode: The macro is executed first, and then the button function is executed. Post macro mode: The button function is executed first, and then the macro is executed. Macro only mode: The button function is not executed, and the macro only is executed. During macro execution, the selected button blinks. Notes • When set to multi mode (see page 347), simultaneous execution of multiple macros is supported using the cross-point buttons on the cross-point control block. Multi mode is disabled if any other buttons or fader levers are operated. • If a button is pressed twice during macro execution or when the macro is stopped, or if another macro is recalled, the following operation depends on a setting in the Setup menu. For details, see "Setting the Macro Operation Mode" (page 432). • Events registered in a macro are executed according to the setup and the device configuration in force when the events were registered. If the state has changed since registration, the contents of the macro may not be reproduced correctly when the macro is recalled. • During macro execution, if you switch the control panel to macro editing mode, the macro currently being executed stops. • During macro editing, pressing a button for which a macro attachment is set does not execute the macro. To disable macro attachment settings Depending on the location of the button you want to disable, press the [MACRO ATTACH ENABLE] button (or button assigned with the "Macro Attachment Enbl" command), turning it off. If using the [MACRO ATTACH ENABLE] button on the cross-point pad or a memory recall button in the utility/ shotbox control block, press it, turning it on dark blue. In this state, pressing a button for which a macro attachment is set does not execute the macro. Executing a macro assigned to a fader lever 1 In the cross-point control block for the fader lever on which you want to execute the macro, press the [MACRO ATTACH ENABLE] button in the crosspoint pad, turning it on orange. 2 Move the fader lever from the start position to the end position. When the fader lever passes the position at which the macro attachment is set, the macro register is recalled, and the macro is executed. Notes • Unless you move the fader lever to the end position (completing the travel), it is not possible to execute the macro again. • When the preset color mix stroke mode is [Normal], the first lever operation executes the macro, but the second lever operation does not. For details about setting the stroke mode, see "Setting a Preset Color Mix" (page 466). • If a button is pressed twice during macro execution or when the macro is stopped, or if another macro is recalled, the following operation depends on a setting in the Setup menu. For details, see "Setting the Macro Operation Mode" (page 432). 366