Sony XVS-7000 Users Guide - Page 395

Setting the Signal Format The combinations of signal formats that can be selected are as follows. Format Field frequency/ Number of effective scan frame frequency lines (pixels) 4K (2SI) 59.94 50 2160P (3840×2160) 4K (SQD) 59.94 50 2160P (3840×2160) 29.97 25 2160PsF (3840×2160) 24 23.98 HD 59.94 1080P 50 29.97 1080PsF 25 24 23.98 59.94 1080i 50 59.94 720P 50 Notes • When using 4K signal formats, software options are required (see page 400). • SWR1 and DME1 (and SWR2 and DME3) signal format settings are linked. • Set devices in a switcher system to the same field frequency/frame frequency signal format. 1 In the Engineering Setup >System >Format menu (7313), select the target device to set. 2 Press [Signal Format]. A pop-up window appears. 3 Press the button for the signal format to set. The status area shows the selected signal format. To clear the signal format setting Press [Clear]. 4 Press [Execute]. 5 Check the message, then press [Yes]. Setting the OETF and Color Gamut You can set OETF (Opto-Electronic Transfer Function) and color gamut information in the payload ID which is added to the output signal. The combinations of settings that can be set are as follows. Signal format 3840×2160P 3840×2160PsF 1080P 1080PsF 1080i 720P OETF SDR HLG, PQ, SLOG3 SDR HLG, PQ, SLOG3 SDR (fixed) Color gamut 709, 2020 2020 709 2020 709 (fixed) Notes • The settings may not be correct if you change the OETF or color gamut at the same time as the signal format. Wait until after the signal format change is completed, and then set the OETF and color gamut. • SWR1 and DME1 (and SWR2 and DME3) settings are linked. • The OETF and color gamut cannot be set when a control panel is selected. • If the switcher signal format is changed to a format that does not support the combination of OETF and color gamut, the default settings ([SDR] OETF and [709] color gamut) are restored. • [SDR] OETF and [709] color gamut are specified in the payload ID which is added to the following output signals. - Output signals down-converted to 1080i 1) - On the XVS-9000, output signals down-converted to 720P 1) • When the OETF is set to [SDR] and color gamut is set to [2020], [709] color gamut is specified in the payload ID which is added to the following output signals. - Multi viewer output signals configured for 1080P format when the switcher signal format is 3840×2160P 2SI - 3840×2160P SQD format and 3840×2160PsF SQD format output signals 1) For outputs down-converted to 1080i or 720P, only the frame size changes, and the OETF and color gamut of the image are maintained. 1 In the Engineering Setup >System >Format menu (7313), select the target device to set. 2 In the group, select the OETF. SDR: Standard Dynamic Range HLG: Hybrid Log Gamma PQ: Perceptual Quantization SLOG3: S-Log3 395