Sony XVS-7000 Users Guide - Page 46

Button name BANK1 to BANK20 TRANS RATE1 to TRANS RATE3 (transition rate 1 to transition rate 3) KF MCRO EDIT (keyframe macro edit) Description (Assignment of the [BANK7] to [BANK20] buttons in the Setup menu is required.) Switches the memory recall buttons to the function recall mode set in the selected bank. Switches the memory recall buttons to transition rate display mode. Switches the memory recall buttons to keyframe/macro editing mode. b Keyframe control buttons Executes keyframe effects. You can change the assignment of keyframe control buttons in the Setup menu. For details, see "Setting Utility/Shotbox Control Block Button Assignments" (page 411). Button name EFF LOOP (effect loop) STOP NEXT KF (stop next keyframe) NORM (normal) NORM/REV (normal/ reverse) REV (reverse) REWIND RUN Description Sets the mode for repeatedly executing an effect. Sets the mode to repeatedly execute/stop effects for each keyframe. Sets the effect execution direction to normal (from beginning to end). Sets the effect execution direction to normal/reverse (automatically toggles each time execution finishes). Sets the effect execution direction to reverse (from end to beginning). Returns to the first keyframe of the effect. • Executes an effect from the first keyframe. • When paused, execution stops at that point, and then resumes when you press the [RUN] button. c Memory recall buttons This section displays the functions assigned to the buttons for the selected operation mode. Note When two utility/shotbox control blocks are used, the memory recall button settings for the same mode selection buttons are common to both blocks. Function recall mode This displays the function specified in the selected bank. You can change the assignment of the following functions to the memory recall buttons in the Setup menu. • Menu shortcut • Utility command • Macro register • Shotbox register For details, see "Assigning a Function to a Memory Recall Button in the Utility/Shotbox Control Block" (page 423). Transition rate display mode This mode displays the transition rate set in the image creation banks (M/E-1 to M/E-5, PGM/PST) and keys (KEY1 to KEY8). Pressing a button displaying a transition rate enables you to enter a transition rate using the numeric keypad control block. You can change the assignment of transition rate display buttons in the Setup menu. For details, see "Setting the transition rate target to display on memory recall buttons" (page 426). Keyframe/macro editing mode This mode displays buttons used for editing keyframe effects and macros. You can edit effects and macro registers recalled using the numeric keypad control block. AUX Bus Control Block You use the AUX bus control block for bus signal selection and router operations. You switch between AUX bus operation mode and router operation mode using the [RTR MODE] button on the cross-point pad. Note To use as an AUX bus control block, the control panel target row must be set to an AUX row in the Engineering Setup >Panel >Config menu (7321). For details, see "Setting the Configuration for Each Bank" (page 406). 46