Sony XVS-7000 Users Guide - Page 293

To clear the start point, stop point, and variable speed settings In the upper list of the status area, select the device, and press [Clear] in the group, group, or group. To set the action for a rewind operation On the DDR/VTR timeline, when the [REWIND] button in the utility/shotbox control block is pressed the action set for the first keyframe is not executed; when the [RUN] button is pressed, then the first keyframe action is executed. To execute an action when the [REWIND] button is pressed, it is necessary to set this action (Rewind Action). To set the Rewind Action, press [Rewind Action] in the Device >DDR/VTR >Timeline menu (5332) to open the Rewind Action menu (5332.1). Operate in the same way as in the DDR/VTR >Timeline menu (5332), and press [Rewind Action Set] to carry out the setting. To set the currently loaded file as the target of Rewind Action, press [File Set]. Alternatively, you can make settings in the Setup menu so that when the [REWIND] button is pressed, this executes the action set for the first keyframe, and when the [RUN] button is pressed the first keyframe action is not executed. In this case, the Rewind Action setting is still valid. For details, see "Setting the first keyframe when rewind is executed" (page 429). Disk Recorder File Operations Recorded material on a disk recorder is managed as files. Loading files To control playback and other operations on a disk recorder, a target file from the file list in the disk recorder must be loaded. The name of the loaded file is displayed on the display of the device control block. Notes • For Extended VTR, "Effect file #xx" (where xx is the register number) is displayed for the file name. • Folder selection is required for the AMP protocol. The files in the selected folder are displayed in the file list. File list sharing You can share the file list between serial ports connected to the same disk recorder. For details, see "Configuring file list sharing" (page 428). Updating a file list Note The files in the selected folder are displayed in the file list for the AMP protocol. For details, see "Selecting a folder" (page 294). 1 Open the Device >DDR/VTR >File List menu (5333). The upper part of the status area shows the device number selected as the target, and the path and name of the selected file. The lower part of the status area shows the file list for the selected device. The file list shows the file name, the length of the file (timecode value), and the update date and time of the files. Notes • The update date and time of the files are not displayed for the video disk communications protocol. When "Simple VDCP" is selected as the device type, the file length is also not displayed. • The file length and update date and time are not displayed for the Odetics protocol and Extended VTR. • The file update date and time are not displayed for the AMP protocol. 2 Select a device. No. Parameter Adjustment 1 DEV Device number 3 Press [File List Update]. The file list is updated. To sort the files in the list In the group, select the sorting method. File No: Sort by file number (low t high order) File Name: Sort by file name (ASCII code order) Update: Sort by file update date and time (new t old order) Notes • Files cannot be sorted for Extended VTR. • Files cannot be sorted by the file update date and time for the video disk communications protocol, Odetics protocol, and AMP protocol. Note A file list cannot be shared for the AMP protocol. 293