Sony XVS-7000 Users Guide - Page 535
Network AUX Remote Panel
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 535 highlights
Network AUX Remote Panel A network AUX remote panel is a function that provides a simple connection of an MKS-R3210/R1620 Remote Control Panel with a switcher, and uses the MKS-R3210/ R1620 Remote Control Panel as a switcher remote panel. You can control the switching of cross-points on a switcher from a remote panel on the network. In a simple connection, the MKS-R3210/R1620 Remote Control Panel and switcher are connected via the switcher control station, without using LSM (Live System Manager). Network AUX remote panel restrictions • Up to 16 remote panels can be configured for a single control panel. • Simultaneous use with an MKS-8080/8082 AUX Bus Remote Panel is not supported. • The network AUX remote panel function is not available if the MKS-R3210/R1620 Remote Control Panel is connected to an LSM. • The network AUX remote panel function is not available if NS-Bus protocol control is enabled on the switcher control station. • The following function and settings restrictions apply to a remote panel. Item Functions Levels Operation button colors Source/ destination names Restrictions The following functions are not available. • Global salvo • Protect • Monitor • Retrace • Linkage Only 1 to 8 are available. Set to "Local" (Color Settings on the Display Settings page) Select from the following two types of alias names. (Alias Name Lists page) • Source name set on the switcher, and fixed bus name • Type+Num name Network AUX remote panel settings The following settings are required in order to use the network AUX remote panel function. MKS-R3210/R1620 Remote Control Panel settings On the Network Settings page of the web menu, configure the network (LAN1). For details about setup, refer to the ICP-X7000 Installation Manual and the MKS-R3210/R1620 Operating Instructions. Switcher control station settings Configure the following in Maintenance Menu. • AUX Remote Panel Config screen Set the remote panel connection to use with the target control panel. • Network Setting screen Allow access if the switcher control station functions as an NTP server. For details about setup, refer to the ICP-X7000 Installation Manual. Switcher settings To use the same cross-point settings as the switcher on a remote panel, copy the cross-point assign table in the Engineering Setup >Panel >Xpt Assign menu (7322). For details, see "Copying Cross-Point Settings" (page 415). Remote panel connection status You can check the remote panel status in the Diag >System Info >Network Aux Remote Status menu (7422). For details, see "Remote Panel Connection Status" (page 493). 535