Sony XVS-7000 Users Guide - Page 464
Split 4, Green, Tally display, To change the output signal format
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 464 highlights
You can select a screen layout from the following eight options. Split-by-4 screen Split-by-10 screen: Pattern 1 Split-by-10 screen: Pattern 2 Split-by-13 screen: Pattern 1 Split-by-13 screen: Pattern 2 Split-by-13 screen: Pattern 3 Split-by-13 screen: Pattern 4 Split-by-16 screen 1 In the Engineering Setup >Switcher >Output menu (7333), press [Multi Viewer]. The Multi Viewer menu (7333.9) appears. 2 In the group, select the target multi viewer to set. On the XVS-9000, select from 1 to 4. On the XVS-8000/7000/6000, select 1 or 2. The status area shows a list of signals that can be assigned to the sub screens. 3 In the group, set the screen layout. Split 4: Split the screen into 4 sub screens. Split 10: Split the screen into 10 sub screens. Split 13: Split the screen into 13 sub screens. Split 16: Split the screen into 16 sub screens. When [Split 10] or [Split 13] is selected, set the layout pattern. No. Parameter Adjustment 4 Pattern Screen split pattern a) a) For [Split 10], patterns 1 and 2 are available. For [Split 13], patterns 1 to 4 are available. 4 To display a border on the sub screens, press [Border Enable], turning it on. Tally display Tallies are shown on the multi viewer screen for the signals used in the on-air video. The tally is represented by sub screen borders using the following two colors. Red: Video with red tally (on-air tally) Green: Video with green tally For details about tally settings, see "Setting the On-Air Tally" (page 428) and "Configuring Tally Generation" (page 487). Note When [Independ] is selected in the group in the Engineering Setup >Panel >Operation >Button Tally menu (7326.9), tallies are not displayed on the multiviewer screen. To change the output signal format When the switcher signal format is 3840×2160P 2SI, the multi viewer output signal format can be set to 1080P or 3840×2160P. Notes • On the XVS-9000, the output signal format cannot be selected. • When using the multi viewer output connectors of a network connector board (XKS-T8165/XKS-Q8166/ XKS-C8166), the board must be reset after changing the multi viewer output format. For details about resetting a board, see "Initializing Network Interface Settings" (page 388). 1 In the Engineering Setup >Switcher >Output >Multi Viewer menu (7333.9), select the target multi viewer to set. 464