Sony XVS-7000 Users Guide - Page 418
Assigning a delegation button to a, destination, Setting the source table
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 418 highlights
Assigning a delegation button to a destination You can assign destinations to the 1st row/2nd row delegation buttons of the AUX bus control block (router operation mode). 1 In the Engineering Setup >Panel >Aux Assign menu (7323), press [RTR Mode Setting]. The RTR Mode Setting menu (7323.1) appears. The left side of the status area shows the button numbers, destination names, and source table numbers. The right side of the status area shows a list of assignable destinations. 2 Select the target button number to set and the destination to assign. To inhibit operation of buttons, press [Inhibit]. Note When a button with number 65 to 128 is selected, the source table selection is automatically disabled, and the [Inhibit] setting is also disabled. 3 Press [Dest Set]. 4 When a button with number 1 to 64 is selected in step 2, select the source table. No. Parameter Adjustment 3 Source Source table number Table 5 Press [Source Table Set]. 6 Repeat steps 2 to 5 as required. To set the [SHIFT] button operation In the group, select one of the following. Hold: The destination on the shifted state of the delegation button is enabled while pressing the [SHIFT] button. Lock: Pressing the button toggles between the destinations on the shifted and unshifted state of the delegation buttons. Note The [SHIFT] button operation mode is enabled only when second delegation mode is set. Setting the source table You can assign sources to the 3rd row/4th row cross-point buttons of the AUX bus control block (router operation mode). 1 In the Engineering Setup >Panel >Aux Assign >RTR Mode Setting menu (7323.1), press [Source Table Assign]. The Source Table Assign menu (7323.2) appears. 2 In the group, select the target source table to set. 3 Press [Table Assign]. The Table Assign menu (7323.3) appears. 4 Select the target button number to set and the source to assign. To inhibit operation of buttons, press [Inhibit]. 5 Press [Source Set]. To set the [SHIFT] button operation In the group of the Source Table Assign menu (7323.2), select one of the following. Hold: The source on the shifted state of the cross-point button is enabled while pressing the [SHIFT] button. Lock: Pressing the button toggles between the sources on the shifted and unshifted state of the cross-point buttons. Off: Functions as a cross-point button, namely, button number 20 on a 20-button system, button number 28 on a 28-button system, and button number 36 on a 36-button system. Note The [SHIFT] button operation mode is enabled only when second delegation mode is set. Assigning levels to level selection buttons 1 In the Engineering Setup >Panel >Aux Assign >RTR Mode Setting menu (7323.1), press [Level Button Assign]. The Level Button Assign menu (7323.4) appears. 2 In the group, select the target button to set. 3 In the group, select the level to assign to the button. You can select more than one level. You can also duplicate the selection on another button. 418