Sony XVS-7000 Users Guide - Page 394
Settings Relating to Signal Formats, Specifying the DME Used on the, Switcher
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 394 highlights
To clear the switcher and master panel settings Press [Clear]. 4 Press [Execute]. 5 Check the message, then press [Yes]. Specifying the DME Used on the Switcher 1 In the Engineering Setup >System >System Config menu (7312), specify the DME to use. When selecting a DME on SWR1: Select [DME1] in the group. When selecting a DME on SWR2: Select [DME3] in the group. 2 Press [Execute]. 3 Check the message, then press [Yes]. Settings Relating to Signal Formats About 4K format In 4K format, a single 4K image is split and transferred as four HD images. Image processing on the switcher is also performed on each of the four images subdivided using 2-sample interleave division method (2SI) or square division method (SQD). In 4K format, the maximum number of switcher banks, keys, inputs, and outputs that are available is as follows. Item Switcher banks Keys Inputs Outputs MV outputs FC outputs Switcher XVS-9000 XVS-8000 XVS-7000 XVS-6000 5 5 3 2 4 per switcher bank (2 keys + 2 sub keys) a) 80 b) c) 40 28 16 40 b) c) 12 12 6 8 b) c) d) e) 2 2 2 - 4 4 f) 4 a) When the signal format is 3840×2160PsF SQD, sub keys cannot be used. b) When the signal format is 3840×2160PsF SQD, up to 40 inputs, 20 outputs, and 4 multi viewer outputs are available. c) On the XKS-C9111N/XKS-C9121N, input/outputs 7 and 15 on each board cannot be used. Accordingly, when only XKS-C9111N/ XKS-C9121N boards are installed, up to 60 inputs, 30 outputs, and 6 multi viewer outputs are available. d) Output signals can be assigned to the multi viewer output connectors. e) When the signal format is 3840×2160P SQD, up to 4 multi viewer outputs are available when multi viewer output signals are assigned, or up to 8 outputs when signals other than multi viewer output signals are assigned. f) Two format converter outputs are designated for output signal conversion. For details, see "Setting the Internal Format Converters" (page 459) and "Assigning a signal to a format converter output" (page 460). For details about restrictions of functions and settings for the 4K format, see "4K Format Restrictions" (page 525). Restrictions on re-entry by signal format Restrictions apply to re-entry signal selection, depending on the signal format and M/E configuration. For details, see "Re-entry signal restrictions" (page 76). 394