Sony XVS-7000 Users Guide - Page 332

For details, see "Assigning a Region to the Region Selection Buttons in the Numeric Keypad Control Block" (page 409). 1 In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button. This switches the memory recall section to snapshot operation mode. The last recalled bank is displayed on the M/E-1 bank. 2 Select the target bank for operation using the bank selection buttons. Select from bank 0 to 9 (register number 1 to 99) for the snapshot. For details about bank selection, see "Bank and register selection in the Flexi Pad control block" (page 331). 3 To add temporary attributes (see page 327), press the following buttons, turning them on. Control block Crosspoint control block Flexi Pad control block Temporary attribute A/B bus crosspoint hold Key cross-point hold Key disable Effect dissolve Auto transition Button [XPTHLD A] and [XPTHLD B] buttons of the cross-point pad [XPTHLD KEY1] to [XPTHLD KEY8] buttons of the cross-point pad a) [XPTHLD KEY1] to [XPTHLD KEY8] buttons of the cross-point pad b) [EFF DISS] button [AUTO TRANS] button a) When the operation mode is set to [Xpt Hold] in the Setup menu. b) When the operation mode is set to [Key Disable] or [Key Dsbl with Status] in the Setup menu. For details about operation modes, see "Setting the operation mode of a cross-point hold button on the key bus" (page 468). Deleting a snapshot 1 In the M/E-1 bank Flexi Pad control block, press the [SNAPSHOT] button. This switches the memory recall section to snapshot operation mode. The last recalled bank is displayed on the M/E-1 bank. 2 Select the target bank for operation using the bank selection buttons. Select from bank 0 to 9 (register number 1 to 99) for the snapshot. For details about bank selection, see "Bank and register selection in the Flexi Pad control block" (page 331). 3 Press and hold the [DEL] button, and press the button of the register in which the snapshot you want to delete is saved. The selected button changes to register number display. Notes • The cross-point hold and key disable settings are maintained until you next press and release the cross-point hold button. • Adding a temporary attribute does not affect the attribute settings saved in registers. 4 Press the button for the register to be recalled. The selected button is lit orange, and the snapshot is recalled. The selected bank and register number are displayed on the top right button in the memory recall section. 332