Sony XVS-7000 Users Guide - Page 414
Setting the [SHIFT] button operation mode, Setting the source signal name
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 414 highlights
2 Select the target table to set. No. Parameter Adjustment 1 Table No Selection of the table to set 3 Select the target button number to set. 4 Select the pair signal to assign. 5 In the group, select one of the following. Set: Delete the signal currently assigned to the selected button number and make a new assignment. Insert: Move the signal currently assigned to the selected button number to the next number, and make a new assignment. To inhibit operation of buttons Select the target button number to set, and press [Inhibit]. To delete a signal assigned to a button Select the button number, and press [Delete] in the group. The signals assigned to numbers following the selected button number move up in sequence. To return the table settings to the defaults Press [Default Recall], check the message, then press [Yes]. Setting the [SHIFT] button operation mode This sets the operation of the [SHIFT] button assigned to the right edge of the cross-point button row. The setting can be configured for each cross-point assign table (main, 1 to 14). Note On the cross-point control block, the [SHIFT] button operation mode is set by the settings of the cross-point assign table of the switcher bank (M/E or P/P), regardless of the buses assigned to the cross-point button rows. 1 In the Engineering Setup >Panel >Xpt Assign >Main, V/K Pair Assign menu (7322.5) or the Engineering Setup >Panel >Xpt Assign >Table Button Assign menu (7322.1), press [Shift Mode]. The Shift Mode menu (7322.13) appears. 2 Select the target table to set. 3 In the group, select the operation mode of the [SHIFT] button. Hold: Functions as a shift button, and the shifted state of the cross-point buttons is enabled while the button is held down. Lock: Functions as a shift button, and pressing the button toggles between the shifted and unshifted cross-points. Off: Functions as a cross-point button, namely, button number 20 on a 20-button system, button number 28 on a 28-button system, and button number 36 on a 36-button system. Setting the [SHIFT ALL] button operation mode This sets the operation mode of the [SHIFT ALL] button assigned to the cross-point pad. This settings is common to all cross-point assign tables. 1 In the Engineering Setup >Panel >Xpt Assign >Main, V/K Pair Assign menu (7322.5) or the Engineering Setup >Panel >Xpt Assign >Table Button Assign menu (7322.1), press [Shift Mode]. The Shift Mode menu (7322.13) appears. 2 Press [Shift All Hold] and set the [SHIFT ALL] button operation mode. To enable the shifted-state cross points for all buses while the button is pressed, press [Shift All Hold], turning it on (hold mode). To switch between shifted-state and unshifted-state cross points for all buses each time the button is pressed, press [Shift All Hold], turning it off (lock mode). Setting the source signal name 1 In the Engineering Setup >Panel >Xpt Assign menu (7322) or the Engineering Setup >Panel >Xpt Assign >Table Button Assign menu (7322.1), press [Src Name/Src Color]. The Src Name/Src Color menu (7322.6) appears. 2 Select the target signal to set. No. Parameter Adjustment 1 Source No Source signal selection 2 Num Number to select 3 Press [Source Name]. 4 Enter a name of up to 16 characters in the keyboard window, and press [Enter]. 414