Sony XVS-7000 Users Guide - Page 76
Re-entry buttons, Re-entry signal restrictions, Extended re-entry
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Overview The cross-point control block and AUX bus control block each have 36 cross-point buttons. These buttons are identified by numbers common to all of the banks and the control block, and a signal is assigned to each number. The basic signal selection process is to select, in a crosspoint button row, the cross-point button to which is assigned the desired signal. Re-entry buttons Re-entry buttons are assigned to the cross-point button rows in the cross-point control block and AUX bus control block (AUX bus operation mode). Re-entry buttons are used to load an image created on a switcher bank (M/E and PGM/PST) as an input signal on another switcher bank. For example, to load the output image from the M/E-1 bank as the background B on the M/E-2 bank, press the M/E-1 re-entry button in the cross-point button row for background B bus in the cross-point control block of the M/E-2 bank. b) For example, if M/E-1 is selected on the M/E-2 background A bus (or background B bus, key bus, utility 1 bus, or utility 2 bus), then M/E-2 cannot be selected on the M/E-3 key bus or utility 1 bus. Extended re-entry The following re-entry signal selections are available when extended re-entry is enabled in the Setup menu. • Re-entry signal selection within the same switcher bank (extended re-entry for switcher banks). • Re-entry signal selection using key bus/utility 1 bus on 3M/E or higher configurations when the switcher signal format is 3840×2160P or 1080P (extended re-entry for keyers). For details, see "Setting Extended Re-Entry" (page 442). Notes • In 36-button rows, the M/E-1 to M/E-3 and PGM/PST re-entry buttons are assigned to buttons numbered 32 to 35. The M/E-4 and M/E-5 re-entry buttons must be assigned in the Setup menu (see page 413). • Re-entry buttons can also be assigned to the cross-point pad (see page 433). • When extended re-entry is enabled for switcher banks, re-entry signals within the same switcher bank can be selected. Re-entry signal restrictions Up to four re-entry stages are supported. The following restrictions apply, depending on the signal format and M/E configuration, for re-entry signal selection. Signal format • 1080P • 3840×2160P • 720P M/E configuration 3M/E to 6M/E 4M/E to 6M/E Restrictions Re-entry signals not selectable on a key bus or the utility 1 bus. a) Re-entry signals spanning more than two stages not selectable on a key bus or the utility 1 bus. b) a) When extended re-entry for keyers is enabled, re-entry signals can be selected on the key bus and utility 1 bus. 76