Sony XVS-7000 Users Guide - Page 211
To set the source name of the converted input, signal, To con the enhancer
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 211 highlights
Notes • The internal format converter function is enabled only when the logical switcher 1 signal format is 3840×2160P 2SI or 3840×2160P SQD, and the logical switcher 2 signal format is 1080P. • The FC channels of internal format converters are set for use as inputs (fixed). • The format converter input signal format is set to 1080P (fixed). • The frame delay level is set to 1 frame (fixed). • The format converter conversion method can be set to Enhancer only. You can assign an input signal to be converted by the format converter to an FC channel. The following signals can be selected as inputs. • Logical switcher 2 frame memory output signals • Logical switcher 2 switcher bank output signals (re- entry signals) 1 In the Engineering Setup >Switcher >Input menu (7332), press [Internal FC Re-Entry Select]. The Internal FC Re-Entry Select menu (7332.11) appears. The status area shows the FC channel list on the left and the list of input signals that can be assigned to FC channels on the right. 2 In the list on the left, select the target FC channel to set. 3 In the list on the right, select an input signal. 4 Press [Set]. To set the source name of the converted input signal 1 Select the target FC channel to set, and press [FC Name]. 2 Enter a name of up to 16 characters in the keyboard window, and press [Enter]. To configure the enhancer 1 Select the target FC channel to set, and press [Enhancer] in the group. 2 Set the following parameters. Parameter group [1/2] No. Parameter 3 Detail Gain 4 Limiter Adjustment Adjust the edge enhancement sharpness Adjust the maximum signal level to be added to the original signal Parameter group [1/2] No. Parameter 5 Crisp Adjustment Set the amplitude value for which low-amplitude signals are not enhanced Parameter group [2/2] No. Parameter 3 Level Depend 4 Frequency Adjustment Set the luminance range for edge enhancement Set the center frequency for edge enhancement a) a) 0 (high frequency) to 2 (low frequency) To return the settings to the defaults In the group, press [Default]. 211