Sony XVS-7000 Users Guide - Page 244

a) Specify minus values to stretch the tiles in the vertical direction. Specify plus values to stretch the tiles in the horizontal direction. To mask the Mosaic effect with a selected pattern Press [Mask] to open the DME >Video Modify >Mask menu (4127), and set the type of pattern and modifiers (see page 246). Sketch Settings Applying the Sketch effect 1 Open the DME >Enhanced Video Modify >Sketch menu (4171). 2 Press [Sketch], turning it on. 3 In the group, select the method for applying outlines. Sketch: Apply touches like a sketch. Edge Color Enhance the outlines. Draw: Apply touches like a line drawing. Relief: Apply touches like a bas-relief effect. Sharp: Apply touches that increase the apparent resolution. 4 Depending on the selection in step 3, set the following parameters. When [Sketch] is selected No. Parameter Adjustment 1 Mix Mix level for Sketch effect video and input video a) 2 Clip Reference level for outline extraction b) 3 Gain Gain level for outline extraction image 4 C Gain Chrominance gain of input video When [Edge Color] is selected No. Parameter Adjustment 1 Mix Mix level for Edge Color effect video and input video a) 2 Clip Reference level for outline extraction b) When [Draw] is selected No. Parameter Adjustment 1 Mix Mix level for Draw effect video and input video a) 2 Clip Reference level for outline extraction b) No. Parameter Adjustment 3 Gain Gain level for outline extraction image When [Relief] is selected No. Parameter Adjustment 1 Mix Mix level for Relief effect video and input video a) 2 Offset Relief luminance level 3 Gain Gain level for outline extraction image 4 Angle Direction of relief image light source When [Sharp] is selected No. Parameter Adjustment 1 H Simultaneously adjust the left and right resolution 2 V Simultaneously adjust the top and bottom resolution 3 All Simultaneously adjust the resolution of all four sides 5 Coring Minimum value of edge to emphasize a) 0.00 is the original input image, and 100.00 gives an image transformed by the effect. b) The larger the [Clip] value, the narrower the outline width. 5 If a setting other than [Sharp] is selected in step 3, use the following procedure as required. To adjust the outline color for [Edge Color] or [Draw] Press [Edge Matte], and set the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue To apply color to sections other than the [Draw] outlines Press [Matte], and set the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue To select the signal to mix with for [Relief] In the group, select the signal to mix with the relief pattern. Matte: Select a single color matte. You can adjust the following parameters. 244