Sony XVS-7000 Users Guide - Page 467
Setting the DME Wipe Edge, Softness Function, Selecting the Bank to Con
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 467 highlights
1 In the Engineering Setup >Switcher >Transition menu (7334), press [Transition Curve]. The Transition Curve menu (7334.2) appears. 2 In the group, select the fader lever operation mode. Normal: The transition progress is linear, according to the fader lever position (factory default mode). Adv Tally Mode: When the fader lever is moved from the end of its travel, the tally is output slightly before the transition starts. Setting the DME Wipe Edge Softness Function You can display the input image filling the frame when executing a DME wipe by disabling the edge softness function. In the Engineering Setup >Switcher >Transition menu (7334), press [Full Size Edge Soft] to enable or disable. Disabling will disable the edge softness function in any of the following cases. • When [Crop] is disabled in the group in the DME Wipe >Modify menu of each switcher bank • When [Crop] is enabled in the group in the DME Wipe >Modify menu of each switcher bank and the [Top] and [Right] parameters are set to "100.00" and the [Left] and [Bottom] parameters are set to "-100.00" • When the DME wipe direction is reverse and before execution of the transition • When [16:9] is selected in the group in the Engineering Setup >Switcher >Config >Side Flags menu (7331.7) Selecting independent key transition mode In the group of the Engineering Setup >Switcher >Transition menu (7334), select one of the following. Same: The transition settings for key insertion and key removal are common. Independ: The transition settings for key insertion and key removal are configured separately. Selecting the background transition flipflop mode In the Engineering Setup >Switcher >Transition menu (7334), press [Bus Toggle] to enable (On) or disable (Off) flip-flop mode. On: Flip-flop mode Off: Bus fixed mode For details, see "Flip-flop mode and bus fixed mode" (page 96). Enabling/disabling split faders In the Engineering Setup >Switcher >Transition menu (7334), press [Split Fader] to enable or disable. Selecting the Bank to Configure In the Engineering Setup >Switcher >Transition menu (7334), select the target bank to set and then configure the bank. No. Parameter Adjustment 1 Bank Switcher target bank selection Setting the transition preview mode In the group of the Engineering Setup >Switcher >Transition menu (7334), select one of the following. One Time: The transition preview ends after a single transition ends. Normal: Pressing the [TRANS PVW] button switches between transition preview mode and normal mode. 467