Sony XVS-7000 Users Guide - Page 430

name set on the router or an NS-Bus alias name set on the system controller. The source name is updated each time the description name/alias name is updated. This allows you to always use the same name between the router/system controller and the switcher. The S-Bus description name/NS-Bus alias name is reflected in the source name setting in the Xpt Assign menu, hence the name set on the router/system controller is also displayed when [Sw'er Local] is selected in the group. To enable the link function for S-Bus In the Engineering Setup >Panel >Operation menu (7326), press [S-Bus Name Link], turning it on. To enable the link function for NS-Bus In the Engineering Setup >Panel >Operation menu (7326), press [NS-Bus Name Link], check the message, then press [Yes]. Note When [NS-Bus Name Link] is enabled, the settings of all source names for the switcher (including wiring traceback), not just in the Xpt Assign menu, are always replaced by the NS-Bus alias name. Setting Flexi Pad Control Block Button Display and Operation In the Engineering Setup >Panel >Operation menu (7326), press [Flexi Pad Mode] to open the Flexi Pad Mode menu (7326.3). Configure each function, as required. Linking the transition type selection with the Flexi Pad control block operation mode Press [Wipe/DME Auto Deleg], turning it on. This switches the operation mode of the Flexi Pad control block in sync with the selection of the [WIPE] button or [DME WIPE] button on the transition control block. Setting the memory recall button display in wipe snapshot operation mode and DME wipe snapshot operation mode In the group, select one of the following. Pattern: Pattern image display Register Name: Register name display Setting the memory recall button display in snapshot operation mode and effect operation mode In the group, select one of the following. Register No.: Register number display Register Name: Register name display Assigning a register to bottom left button of bank 0 In the group, select one of the following. Register Assign: Assign a register. Select the register number using the following parameter. No. Parameter Adjustment 1 Register Register number a) No. a) 1 to 99 configurable only Register No Assign: Disable register assignment. Note The bottom left button of bank 0 cannot be selected in the Misc >Snapshot menu on each switcher bank. Setting the Button and Fader Lever Operation Mode In the Engineering Setup >Panel >Operation menu (7326), press [Custom Button/Fader] to open the Custom Button/ Fader menu (7326.4). Configure each function, as required. Setting the double-press operation mode of the [BKGD] button in the transition control block In the group, select one of the following. Disable: Double-pressing of the [BKGD] button is disabled. Enable: When the [BKGD] button is pressed twice in quick succession, all currently inserted keys are selected and removed by the next transition. Setting the operation mode when the [FTB] button is pressed during fade-to-black In the group, select one of the following. Continue: Continue the fade-to-black. Cancel: Cancel the fade-to-black, and return to the previous state. Setting the operation mode when the [AUTO TRANS] button or [TAKE] button is pressed during an auto transition In the group, select one of the following. Continue: Continue the auto transition. Cancel: Cancel the auto transition, and return to the previous state. Setting the transition indicator display in nonsync state In the group, select one of the following. 430