Sony XVS-7000 Users Guide - Page 356

Deleting an event 1 Specify an edit point (see page 355). 2 Press the [DEL] button in the memory recall section. Deleting all events You can delete all events within the selected macro register. 1 Specify an edit point (see page 355). 2 Press the [ALL] button, turning it on orange. 3 Press the [DEL] button in the memory recall section. Inserting a pause event 1 Specify an edit point (see page 355). 2 If required, set auto insert mode (see page 354). 3 Press the [PAUSE] button. This switches the memory recall section to numeric keypad mode. 4 Enter the pause duration (0, or 1 to 999 frames), and press the [ENTER] button. When auto insert mode is enabled, the pause event is registered after the current event automatically. When auto insert mode is disabled, press the [INS] button to register the pause event after the current event. Note In auto pause insert mode, the [PAUSE] button operation is automatically registered as an event, but a pause event is not inserted automatically between the event and the next event. Deleting a Macro 1 In the Flexi Pad control block, press the [MCRO] button. This switches the memory recall section to macro operation mode. The last recalled bank is displayed. 2 Use the bank selection buttons to select the target bank for operation. Select from bank 0 to 25 (register number 1 to 250). For details about bank selection, see "Bank and register selection in the Flexi Pad control block" (page 331). 3 Holding down the [DEL] button, press the button of the register in which the macro you want to delete is saved. Saving a Macro Press the [STORE XXX] button in the memory recall section (where XXX is the number of the currently selected register). This saves the edited macro in the register. To exit macro editing without saving, press the [EXIT] button. 356