Sony XVS-7000 Users Guide - Page 431
Setting the Operation Mode of the, ALL] Button in the Transition, Control Block
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 431 highlights
Normal: The transition indicator is lit when in non-sync state. Blink: The transition indicator is blinking when in nonsync state. Setting the button display state when executing an auto transition using the [AUTO TRANS] button In the group, select one of the following. Disable: Lit amber during transition execution, and goes off at the end of the transition. Enable: Lit green during transition execution, and at the end of the transition it is lit red if on-air or lit amber if not on-air. Note Enable using the [AUTO TRANS] button in the independent key transition execution section on the transition control block, independent key transition control block, or key fader control block. Setting the [TRANS PVW] button operation mode In the group, select one of the following. Hold: Enables transition preview mode only while the [TRANS PVW] button is pressed. Lock: Pressing the [TRANS PVW] button switches between transition preview mode and normal mode each time the button is pressed. The one-time mode setting is set in the Engineering Setup >Switcher >Transition menu (7334) (see page 467). Setting the [KEY] button operation mode when a key source bus is selected In the group, select one of the following. Key: The [KEY] button is always lit, and only key signals are selected using the cross-point buttons. Video & Key: Enables key signals or video signals to be selected using cross-point buttons, according to the [KEY] button operation. For details about the [KEY] button operation, see "To select a video signal assigned to a cross-point button" (page 112). Setting the [UTIL] button operation mode In the group, select one of the following. Hold: Enables utility bus mode only while the [UTIL] button is pressed. Lock: Pressing the [UTIL] button switches between utility bus mode and normal mode each time the button is pressed. Exchanging the [AUTO TRANS] button and [CUT] button in the transition control block Press [Auto Trans/Cut Swap], turning it on. Setting the Operation Mode of the [ALL] Button in the Transition Control Block This sets the next transition selected by the [ALL] button in the transition control block. 1 In the Engineering Setup >Panel >Operation >Custom Button/Fader menu (7326.4), press [Next Trans All]. The Next Trans All menu (7326.11) appears. 2 In the group, select the button for the next transition. Note If all next transition buttons are disabled, the next transition cannot be set even if the [ALL] button is pressed. Setting Device Control Block Button and Trackball Operation In the Engineering Setup >Panel >Operation menu (7326), press [Sensitivity] to open the Sensitivity menu (7326.5). Configure each function, as required. Setting the trackball and Z-ring sensitivity in normal mode In the group, select one of the following. ×1: Standard (default travel speed) ×2: Move at 2× speed. ×4: Move at 4× speed. Note This setting is disabled in the following operation modes. • Keyframe operation mode • VTR/disk recorder/frame memory operation mode Setting the trackball and Z-ring sensitivity in fine mode In the group, select one of the following. 1/2: Move at 1/2 speed 1/4: Move at 1/4 speed 1/8: Move at 1/8 speed Note This setting is disabled in the following operation modes. • Keyframe operation mode • VTR/disk recorder/frame memory operation mode 431