Sony XVS-7000 Users Guide - Page 488
Tally Copy Settings, Deleting Tally Generation, Setting Advanced Tally, Configuring Tally Copy
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 488 highlights
The Modify menu (7364.2) appears. 2 Refer to steps 2 to 4 in "Configuring Tally Generation" (page 487) and modify the parameters. 3 Press [Execute]. Deleting Tally Generation 1 In the Engineering Setup >Router/Tally >Tally Enable menu (7364), select the tally generation. 2 Press [Delete]. Setting Advanced Tally You can use cross-point delay in combination with the advanced tally function to output a tally prior to the actual switching of the cross-point. When the cross-point delay is configured and advanced tally is enabled, a tally is output when a cross-point is selected and then the cross-point switches after the delay has expired. When advanced tally is disabled, the tally is output in conjunction with cross-point switching. Advanced tally can be set for each tally type (R1 to R8, G1 to G8). Notes • When cross-points are the target of multiple tally types and the advanced tally setting (enable/disable) varies depending on the tally type, cross-point tallies are output with advanced tally enabled. • When a cross-point with cross-point delay and advanced tally enabled is selected, both the target cross-point tallies from before and after cross-point selection are output during the delay period before the cross-point switches. 1 In the Engineering Setup >Router/Tally >Tally Enable menu (7364), press [Advanced Tally Mode]. The Advanced Tally Mode menu (7364.3) appears. 2 In the group, select the tally types. To enable advanced tally, press [R1] to [R8] and [G1] to [G8], turning them on. Tally Copy Settings You can copy the tally information for a particular source to a different source. The settings used are common to both parallel and serial tallies. Configuring Tally Copy 1 In the Engineering Setup >Router/Tally >Tally Copy menu (7365), press [New]. The New menu (7365.1) appears. 2 Set the source to copy. When setting more than one tally copy, you can specify the copy-from source start and end addresses. No. Parameter Adjustment 1 Copy From Copy-from source start address (From) 2 Copy From Copy-from source end address (To) 3 Set the source on the copy destination. No. Parameter Adjustment 3 Copy To Copy-to source start address (From) 4 Copy To Copy-to source end address (To) 4 Press [Execute]. Modifying Tally Copy 1 In the Engineering Setup >Router/Tally >Tally Copy menu (7365), press [Modify]. The Modify menu (7365.2) appears. 2 Select the copy-from and copy-to sources. No. Parameter Adjustment 1 Copy From Copy-from source 2 Copy To Copy-to source 3 Press [Execute]. 488