Sony XVS-7000 Users Guide - Page 460
Setting Internal Format Converter, Outputs, Assigning a signal to a format converter
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 460 highlights
To clear the setting Press [Clear]. 4 Press [Execute]. 5 Check the message, then press [Yes]. Setting Internal Format Converter Outputs You can set internal format converter outputs if the XKS-8460 Format Converter Board is installed. You can convert signals assigned to format converter outputs 1 to 16 using the format converter. Format converter outputs 1 to 16 correspond to the same number channel (FC1 to FC16) of the format converter. Notes • On the XVS-9000, internal format converters are not available. • An FC channel configured for format converter input use cannot be selected. For details, see "Setting the Internal Format Converters" (page 459). • In 4K format, only FC1, FC5, FC9, and FC13 can be configured. • You can assign format converter outputs 1 to 16 to format converter output connectors 1 to 16 or spare connectors 1 to 4 (see page 456). Assigning a signal to a format converter output You can assign a signal to convert by the format converter to the format converter output corresponding to the FC channel. Note On the XVS-7000, the signals on output connectors 9 to 16 are assigned to FC9 to FC16. The format-converted signals are output on format converter outputs 9 to 16, respectively. It is not possible to change settings. For details about output connector signal assignment, see "Assigning Output Signals" (page 456). 1 In the Engineering Setup >Switcher >Output menu (7333), press [Internal FC]. The Internal FC menu (7333.15) appears. 2 Press [FC Output Select]. The FC Output Select menu (7333.14) appears. The status area shows a list of FC channel numbers and source names of the signals assigned to the corresponding format converter output on the left. 3 In the group, set the signals to display in the list on the right. For details, refer to step 2 in "Assigning Output Signals" (page 456). 4 Select the FC channel number and signal to assign. For signals not assigned, select "Undefined" in the signal list or press [Inhibit] to set to "Undefined." 5 Press [Set]. Setting the conversion format You can set the signal format of outputs to convert by the format converter. The conversion format is set in the following groupings, depending on the switcher signal format. • 3840×2160P, 1080P: 4-channel groups (FC1 to FC4, FC5 to FC8, FC9 to FC12, FC13 to FC16) • 1080i, 720P: 8-channel groups (FC1 to FC8, FC9 to FC16) Notes • When the switcher signal format is 3840×2160PsF or 1080PsF, output signal format conversion is not available. • When the switcher signal format is 1080P, the signal formats that can be converted vary depending on the 720P converter setting. For details about the 720P converter, see "Enabling/ disabling the 720P converter" (page 459). Supported formats The supported conversion formats are given below. Notes • Field frequency and frame frequency conversion is not supported. • When the conversion format is set to the same signal format as the switcher, signals are output without format conversion, but the signal delay level is the same as for a format-converted signal. Switcher signal format 3840×2160P (Level A, 2SI) Output signal format • 3840×2160P (Level A, 2SI) a) • 3840×2160P (Level B, 2SI) • 3840×2160P (Level A, SQD) • 3840×2160P (Level B, SQD) • 1080P (Level A) • 1080P (Level B) • 1080i 460