Sony XVS-7000 Users Guide - Page 392
Setting the Network Interface, Protocol, In the Engineering Setup >System >Network Config
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 392 highlights
3 In the status area, select the target slot in which the board is installed. 4 Enable NMOS. Press [NMOS], turning it on. Note When LSM is enabled in the IP Address menu (7311.2), [NMOS] turns off and NMOS of the target board becomes disabled. 5 Enable or disable obtaining an address automatically. To disable, press [RDS Discovery], turning it off. To enable, press [RDS Discovery], turning it on, and skip to step 10. 6 In the group, press [IP Address], and set the IP address of the primary RDS server. Enter the IP address using the keyboard window, then press [Enter]. 7 In the group, press [Port], and set the port number of the primary RDS server. Enter the port number using the numeric keypad window, then press [Enter]. 8 In the group, press [IP Address], and set the IP address of the secondary RDS server. Enter the IP address using the keyboard window, then press [Enter]. 9 In the group, press [Port], and set the port number of the secondary RDS server. Enter the port number using the numeric keypad window, then press [Enter]. 10 Repeat steps 3 to 9 as required. 11 Press [Execute]. 12 Check the message, then press [Yes]. Notes • On the XVS-9000, the protocol cannot be set. Only the following protocols are supported on each network connector board. - XKS-C9111/XKS-C9121: ST2110 - XKS-C9111N/XKS-C9121N: NMI • On the XVS-8000/7000/6000, the protocol cannot be set when the following network connector boards are installed. Only the following protocols are supported on each network connector board. - XKS-T8110/XKS-T8165: NMI - XKS-C8111/XKS-C8166: ST2110 • The protocol setting is common to all slots in which an XKS-Q8111/XKS-Q8166 is installed. If different protocols are displayed among the slots, reconfigure the protocol setting. Network connector boards that use different protocols cannot be installed in a switcher at the same time. 1 In the Engineering Setup >System >Network Config menu (7311), press [Net I/F Protocol]. The Net I/F Protocol menu (7311.3) appears. 2 In the group, select the target switcher to set. 3 In the status area, select a slot. 4 In the group, select one of the following. NMI: Set to NMI. ST2110: Set to SMPTE ST 2110 compliant. The selected protocol is displayed for all slots in which an XKS-Q8111/XKS-Q8166 is installed. 5 Press [Execute]. 6 Check the message, then press [Yes]. Setting the Network Interface Protocol On the XVS-8000/7000/6000 with an XKS-Q8111/ XKS-Q8166 installed, you can set the network interface protocol. NMI (Networked Media Interface) and ST2110 (SMPTE ST 2110 compliant) protocols can be selected. 392