Sony XVS-7000 Users Guide - Page 397

Setting the Screen Aspect Ratio The screen aspect ratio can be set to 16:9 or 4:3. 1 In the Engineering Setup >System >Format menu (7313), select the target device to set. Notes • The screen aspect ratio cannot be selected when a control panel is selected. • In 4K format, the screen aspect ratio is fixed to 16:9. 2 In the group, select one of the following. 16:9: Set the screen aspect ratio to 16:9. 4:3: Set the screen aspect ratio to 4:3. 3 Press [Aspect Execute]. 4 Check the message, then press [Yes]. Power-On (Startup) State Selection You can select the settings of each device at startup. You can also configure the restoration of settings that were previously saved when recalling an initial status file. There are two modes available for selecting settings at startup (Resume mode and Custom mode). Resume mode This resumes operation with the state in force when the power was last turned off. This setting is only available for the switcher and control panel. Custom mode This mode uses settings saved in non-volatile memory within each device. You can set Setup mode and Initial Status mode settings separately. • Setup mode: Set one of the following setup states to use after powering on. User: Start up using the user data previously saved with [Setup Define]. Factory: Start up with the factory default settings. • Initial Status mode: Set one of the following states of each device after powering on (excludes Setup mode settings). User: Start up using the user data previously saved with [Init Status Define]. Factory: Start up with the factory default settings. For details, see "Saving and Recalling Setup Data" (page 398). 397