Sony XVS-7000 Users Guide - Page 229
Applying Special Effects (Common Operations), Applying Special Effects (Edge Effects), Border Settings
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 229 highlights
Applying Special Effects Applying Special Effects (Common Operations) (Edge Effects) This section describes the operation of each effect using the setup procedure in the DME menu. Select the DME channel in the device control block (trackball) before operating the menu. Selecting a DME channel 1 Press the [DME] button on the device control block. 2 Using the channel selection buttons, select the target channel (CH1 to CH4) of the operation. 3 Configure each effect in the DME menu. Border Settings Adding a border 1 Open the DME >Edge >Border/Crop menu (4111). 2 Press [Border], turning it on. 3 Set the following parameters. Parameter group [1/2] No. Parameter Adjustment 1 H Simultaneously adjust border width of left and right edges 2 V Simultaneously adjust border width of top and bottom edges 3 All Simultaneously adjust border width on all edges 5 Density Border density Parameter group [2/2] No. Parameter Adjustment 1 Top Border width on top side 2 Left Border width on left side 3 Right Border width on right side 4 Bottom Border width on bottom side 5 Density Border density Selecting the border color 1 In the group of the Border/Crop menu (4111), select one of the following. Flat Color: Single color Mix Color: Mix color signal set in the DME >Edge >Color Mix menu (4117) (see page 240) Ext Video: External video signal input from Ext In 2 When [Flat Color] is selected in step 1, set the following parameters. No. Parameter Adjustment 1 Luminance Luminance 2 Saturation Saturation 3 Hue Hue 229