Sony XVS-7000 Users Guide - Page 458
Setting the SDI Output Mode, Setting M/E Dedicated Outputs, Setting an Ext Out signal
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 458 highlights
Note When a screen aspect ratio of 16:9 is set in the Engineering Setup >System >Format menu (7313), 4:3 cropping is disabled. 1 In the Engineering Setup >Switcher >Output menu (7333), press [4:3 Crop]. The 4:3 Crop menu (7333.5) appears. 2 Select the target output to set. 3 Press [4:3 Crop], turning it on. Setting the SDI Output Mode When an XKS-S8167 12G-SDI Output Board is installed in the XVS-8000/7000/6000, you can set the output mode of 3840×2160P 2SI (Level A) format signals. Select 12G mode or 3G mode for each group of four output connectors assigned to 4K signals. In 12G mode, 3840×2160P 2SI (Level A) format signals are output as a 12G×1 signal. In 3G mode, they are output as 3G×4 signals. Notes • This setting is available only when the switcher signal format is 3840×2160P. • When the switcher signal format is 3840×2160P SQD, this setting is available only for format converter output connectors and spare connectors. 1 In the Engineering Setup >Switcher >Output menu (7333), press [SDI Mode]. The SDI Mode menu (7333.19) appears. 2 In the status area, select the target output connector group to set. To select all groups, press [ALL]. To select multiple groups, set the number using the [Num] parameter. The specified number of groups are selected from the currently selected group. 3 In the group, select the SDI output mode. 12G: Set to 12G mode. 3G: Set to 3G mode. To clear the output mode setting Press [Clear]. 4 Press [Execute]. Setting M/E Dedicated Outputs On the XVS-8000, four M/E dedicated outputs are supported when the switcher signal format is 3840×2160P. Note To use M/E dedicated outputs, an XKS-S8165 SDI Output Connector Board must be installed in slot 2 of the switcher. Setting the Ext Out mode You can enable either the M/E dedicated output or DME, since they use the same output (Ext Out) on each switcher bank. By default, Ext Out is configured for DME use. To enable M/E dedicated output, Ext Out must be configured for M/E dedicated output use. Notes • The Ext Out mode setting is common to all the M/E and PGM/PST banks. • If Ext Out is set for M/E dedicated output use, all functions relating to DME effects (DME, DME wipe, image effect) cannot be used in 4K format. 1 In the Engineering Setup >Switcher >Output menu (7333), press [M/E Dedicated Out Assign]. The M/E Dedicated Output Assign menu (7333.8) appears. 2 In the group, select the Ext Out mode. DME: Use Ext Out for DME. Dedicated Output: Use Ext Out for M/E dedicated output. Setting an Ext Out signal You can configure two outputs (Ext Out1, Ext Out2) on each switcher bank to use with M/E dedicated outputs. The following signals assigned to Out1 to Out4 using the Engineering Setup >Switcher >Config >M/E Output Assign menu (7331.1) can be set as an Ext Out signal. • Program outputs • Preview output • Clean output • Key preview outputs 1 In the Engineering Setup >Switcher >Output menu (7333), press [M/E Dedicated Out Assign]. The M/E Dedicated Output Assign menu (7333.8) appears. 458