Sony XVS-7000 Users Guide - Page 390
Setting the IP address, RS-FEC, FC-FEC
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 390 highlights
4 In the group, select one of the following. RS-FEC: Use Reed-Solomon FEC (CL108). 1) FC-FEC: Use Fire-Code FEC (CL74). None: Do not use FEC. 1) RS-FEC defines CL91 for 100G, and CL108 for 25G. The unit supports 25G×4 to achieve 100G, so only CL108 is used. 5 Repeat steps 3 and 4 as required. 6 Press [Execute]. 7 Check the message, then press [Yes]. Setting the IP address You can set the IP address and enable/disable LSM (Live System Manager) for each network. Note Enabling LSM for an XKS-C8111/XKS-C9111/ XKS-C9121/XKS-C8166 board will disable the NMOS settings in the NMOS menu (7311.7). 1 In the group of the Engineering Setup >System >Network Config menu (7311), press [IP Address]. The IP Address menu (7311.2) appears. 2 In the group, select the target switcher to set. The status area shows the slot number, network settings status, and the MAC address of the selected network interface. 3 In the status area, select the target network to set. Note When multiple networks are selected, if the network with the lowest number is a main network, only main networks are the target for configuration. Likewise for sub networks. 4 Enable or disable DHCP. To disable, press [DHCP] in the group, turning it off. To enable, press [DHCP] in the group, turning it on, and skip to step 8. Note The DHCP settings for main and sub on a single network are linked. Disable DHCP when not performing the initial setup. 5 In the group, press [IP Address], and set the IP address. Enter the IP address using the keyboard window, then press [Enter]. If multiple networks are selected, this sets the IP address for the network with the lowest number, and the IP addresses of subsequent networks are incremented by 1 for each network. 6 In the group, press [Subnet Mask], and set the subnet mask. Enter the subnet mask using the keyboard window, then press [Enter]. If multiple networks are selected, the same subnet mask is set for each network. 7 In the group, press [Gateway], and set the default gateway IP address. Enter the IP address using the keyboard window, then press [Enter]. If multiple networks are selected, the same IP address is set for each network. 8 Enable or disable LSM. To enable, press [Enable] in the group, turning it on. To disable, press [Enable] in the group, turning it off, and skip to step 10. Notes • LSM is enabled on the main network. It is not possible to change the setting. • If an XKS-C8111/XKS-C9111/XKS-C9121/ XKS-C8166 is installed, LSM cannot be disabled by pressing [Enable]. When NMOS is enabled in the NMOS menu (7311.7), [Enable] turns off and all LSM instances on the network of the target board become disabled. 9 In the group, press [IP Address], and set the LSM IP address. Enter the IP address using the keyboard window, then press [Enter]. If multiple networks are selected, the same IP address is set for each network. Note The IP address cannot be set when DHCP is enabled. 10 Repeat steps 3 to 9 as required. 11 Press [Execute]. 390