Sony XVS-7000 Users Guide - Page 387
System Setup, Settings Relating to the Network, Network
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 387 highlights
System Setup 17 Chapter About system setup This configures the setup for the whole system. Here, the "whole system" refers to all devices connected on the switcher system LAN. Unit ID settings When there are two switchers on the same network, the unit IDs are set as follows. Switcher 1st switcher 2nd switcher Unit ID 1 2 The unit IDs for DMEs are automatically assigned as follows. DME DME of 1st switcher (Ch1 to Ch4) DME of 2nd switcher (Ch1 to Ch4) Unit ID 1 3 Menu panel unit IDs are set in the Engineering Setup >System >Network Config menu (7311) (see page 387). For details about unit IDs of devices other than the menu panel, refer to the installation manual for each device. Settings Relating to the Network This section describes the configuration of devices connected to the switcher system LAN. Setting the Group ID and Unit ID of the Menu Panel 1 In the Engineering Setup >System >Network Config menu (7311), press [Group ID]. 2 Enter the group ID number (1 to 8) using the numeric keypad, then press [Enter]. 3 Perform the following operations. To set the group ID only: Check the message, then press [Yes] to exit the settings. To set the unit ID: Check the message, then press [No] and skip to step 4. 4 Press [Unit ID]. 5 Enter the unit ID number (1 to 4) using the numeric keypad, then press [Enter]. 6 Check the message, then press [Yes]. Configuring the NFS Server Set the address of the NFS server to use. 1 In the Engineering Setup >System >Network Config menu (7311), press [NFS Server]. 2 Enter the server address using the keyboard window, then press [Enter]. 387