Sony XVS-7000 Users Guide - Page 324

Editing Registers Using the Effect menu, you can carry out the following effect register operations. • Effect status display (see page 324) • Effect attribute settings (see page 324) • Effect register editing (see page 324) This section describes the menu for effect registers 1 to 99 as an example. Carry out similar operations in the User DME Wipe Effect 101-199 menu, User DME Wipe Effect 201-299 menu, and User DME Wipe Effect 301-399 menu for user programmable DME registers. Carry out similar operations in the DEV/PBUS Effect 1-250 menu for P-Bus and Device1 to Device12 registers. Effect Status Display The Effect >Effect 1-99 menu displays the following information. Region name: The selected region name appears in the upper part of the list. Register number Register name Write-protected status: When the register is write- protected, an "L" appears. Empty status: When the register is empty, an "E" appears. Effect Attribute Settings Applying effect dissolve Apply the "effect dissolve" attribute to a keyframe effect. 1 Open the Effect >Effect 1-99 >Attribute menu (6221). 2 Press the region display in the upper part of the list to display a selection window, then select the region in the selection window. You can select more than one region. To select all regions, press [ALL]. To select all switcher-related regions (M/E, P/P, User), press [SWR ALL]. 3 Press [OK]. 4 Select a register. To select all registers, press [ALL]. To select multiple registers, set the [Num] parameter. To select multiple registers with the [Num] parameter Specify the register number in the [Register] parameter, and set the quantity in the [Num] parameter. The specified amount of registers is selected from the specified register number. 5 Press [Effect Dissolve], turning it on. 6 Set the duration. No. Parameter Adjustment 4 Eff Diss Dissolve duration Duration To set the duration for a temporary attribute Set the duration for a temporary attribute set in the numeric keypad control block using the following parameters. No. Parameter Adjustment 5 Temp Dur Temporary attribute dissolve duration Effect Register Editing You can carry out the following editing on effect registers and master timeline registers. • Lock: Write-protect the data contents of the register. • Copy: Copy data between registers. • Merge: Merge the data of two registers. It is not possible to merge master timeline registers. • Move: Move data between registers. • Swap: Swap the contents of two registers. • Delete: Delete the data contents of a register. • Name: Attach a name to a register. Write-protecting the contents of the effect register Note It is not possible to write-protect an empty register. 1 Open the Effect >Effect 1-99 >Lock menu (6222). 2 Press the region display in the upper part of the list to display a selection window, then select the region in the selection window. You can select more than one region. To select all regions, press [ALL]. To select all switcher-related regions (M/E, P/P, User), press [SWR ALL]. 3 Press [OK]. 324