Sony XVS-7000 Users Guide - Page 161
Modifying a DME wipe pattern edge Edge, Setting the DME wipe pattern position, Positioner
View all Sony XVS-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 161 highlights
2 In the group, specify the DME wipe direction. Normal: DME wipe in the normal direction. Normal/Reverse: DME wipe in the normal and reverse direction alternately for each transition. Reverse: DME wipe in the opposite direction to normal. To specify the DME wipe direction with a button in the transition control block In the transition control block of each bank, press the wipe direction selection buttons. NORM: Normal 1) NORM/REV: Normal/reverse REV: Reverse 1) When the [REV] button is not lit if using the transition control block (simple type). Modifying a DME wipe pattern edge (Edge) 1 Open the M/E-1 >DME Wipe >Edge/Direction menu (1164). 2 In the group, select the target channels. For a pattern in 1-channel mode: Select [1st Ch]. For a pattern in 2-channel mode or 3-channel mode: Select the corresponding channels. You can select more than one channel at the same time. 3 In the group, select the edge type. Border: Border Soft Border: Soft border 4 Depending on the selection in step 3, set the following parameters. When [Border] is selected No. Parameter Adjustment 1 Width Border width 3 Luminance Luminance of border color 4 Saturation Saturation 5 Hue Hue When [Soft Border] is selected No. Parameter Adjustment 1 Width Border width 2 Inner Soft Degree of softness inside the border 3 Luminance Luminance of border color 4 Saturation Saturation 5 Hue Hue Display indications when multiple channels are selected at the same time The parameter setting value display shows the settings of the lowest-numbered channel. When you adjust the settings, this adjusts the settings on the other channels by the same amount. Setting the DME wipe pattern position (Positioner) 1 Open the M/E-1 >DME Wipe >Modify menu (1165). 2 In the group, select the target channels. For a pattern in 1-channel mode: Select [1st Ch]. For a pattern in 2-channel mode: Select the corresponding channels. You can select more than one channel at the same time. 3 In the group, press [Position], turning it on. 4 Set the following parameters. No. Parameter Adjustment 1 H Horizontal position 2 V Vertical position Display indications when multiple channels are selected at the same time The parameter setting value display shows the settings of the lowest-numbered channel. When you adjust the settings, this adjusts the settings on the other channels by the same amount. To return the DME wipe pattern position to the center of the screen In the group, press [Center]. Displaying/moving the DME wipe pattern position 1 Open the M/E-1 >DME Wipe >Modify menu (1165). In the group, [Top Left], [Top Right], [Bottom Left], or [Bottom Right] is lit to indicate the current display position of the DME wipe pattern. 2 In the group, press [Position], turning it on. 3 In the group, select the target channels. For a pattern in 1-channel mode: Select [1st Ch]. For a pattern in 2-channel mode: Select the corresponding channels. You can select more than one channel at the same time. 161