Sony XVS-7000 Users Guide - Page 204

Notes • Settings are linked with the Engineering Setup >Switcher >Config >PGM Config menu (7331.2). • Cannot be configured when the Engineering Setup >Switcher >Config >PGM Config menu (7331.2) is locked or when [Recall M/E Config] is disabled in the Engineering Setup >Switcher >Config menu (7331). 1 Open the M/E-1 >Misc >Key Assign menu (1175). The current key assignment is shown in the status area. 2 Change the key assignment in the "Key Enable" field. Keys recalled in a snapshot recall If a snapshot is recalled independently on the main bank or sub bank, this only retrieves the settings for the key assigned to the recalled bank. For example, if key 1 and key 2 are assigned on the main bank, and key 3 and key 4 are assigned on the sub bank, then if you recall a snapshot on the main bank, this only retrieves the settings for key 1 and key 2, and the state of key 3 and key 4 assigned on the sub bank is not affected. Assigning sub bank preview output to buttons The "Sub Preview" utility command on each switcher bank can be assigned to the following buttons. • Cross-point buttons on the cross-point control block in utility/shotbox mode • Memory recall buttons in the utility/shotbox control block • User preference buttons in the menu panel For details, see "Settings Relating to Button Assignment" (page 419). Setting the matrix size When using a router, if the matrix size is set to [128×128], it is not possible to control the utility 3 bus on the S-Bus/ NS-Bus. When using Multi Program 2, select a size other than [128×128] in the group of the Engineering Setup >Router/Tally >Router menu (7361). For details, see "Assigning Switcher Inputs/Outputs to SBus/NS-Bus Space" (page 484). If [136×138] is selected in the group, the bus number of the DME Key bus is used as the bus number of the utility 3 bus. No. Bus (Standard) 70 M/E-1 DME Key 85 M/E-2 DME Key Bus (MP2) M/E-1 Utility3 M/E-2 Utility3 No. Bus (Standard) 100 M/E-3 DME Key 115 P/P DME Key Bus (MP2) M/E-3 Utility3 P/P Utility3 Making settings for keyframe timeline operation To assign a sub bank region to a region selection button in the numeric keypad control block In the Engineering Setup >Panel >Config >10 Key Region Assign menu (7321.7), assign sub bank region to the region selection button in the numeric keypad control block. For details, see "Assigning a Region to the Region Selection Buttons in the Numeric Keypad Control Block" (page 409). To select a region or reference region using the menu During snapshot or keyframe operations, you can select a region (including sub bank) in the Key Frame >Region Select menu (6117). This is convenient for selecting some of the regions assigned to the numeric keypad control block or changing the reference region. For details, see "Recalling regions to edit (menu)" (page 307). To assign regions shown in the timeline menu The timeline and other information is displayed for each region assigned in the numeric keypad control block in the Key Frame >Time Line menu (6111). You can set the display method in the Key Frame >Timeline Assign menu (6115). For details, see "Timeline Menu Display Settings" (page 304). Setting extended re-entry For multi program 2, enabling extended re-entry enables re-entry between main and sub, between main and main, and between sub and sub on the same switcher bank. For details, see "Setting Extended Re-Entry" (page 442). 204